Influence of stirrup spacing on shear resistance and deformation of reinforced concrete beams

Influence of shear reinforcement corrosion on the performance of under-reinforced concrete beams

Reinforced concrete beams are normally designed as under-reinforced to provide ductile behaviour at failure i.e. the tensile moment of resistance, Mt(0), is less than the moment of resistance of the compressive zone, Mc. Since it is well established that the steel in reinforced concrete beams is prone to corrosion, the residual flexural strength is normally the main concern of asset managers. H...

Influence of flanges on the shear-carrying capacity of reinforced concrete beams without web reinforcement

Development of Shear Capacity Equations for Rectangular Reinforced Concrete Beams

The problem of shear is not yet fully understood due to involvement of number of parameters. Designers are extra careful about shear, especially in beams and consequently higher safety factors are used in shear design. Several equations are available in literature to determine the shear capacity of beams, i.e. ACI equation, Zsutty equation and KIM & White equation. To verify the application of ...

Hysteretic Behavior of Conventionally Reinforced Concrete Coupling Beams in Reinforced Concrete Coupled Shear Wall

This paper presents the experimental results of four full-scale coupling beams in which only horizontal reinforcements are placed, without diagonal reinforcements, with the aim to develop reinforcement details for coupling beams used in connecting side walls in a wall-slab structural system. Each coupling beam specimen was designed according to the deep-beam design procedure that does not use d...

Shear Strength of Slender Reinforced Concrete Beams without Web Reinforcement

This paper attempt to predict the shear strength of high strength concrete beam with different shear span of depth ratio without web reinforcement. The large data base available has been clustered and a linear equation analysis has been performed . The prepared models are functions of compressive strength , percentage of flexural reinforcement and depth of beam. The proposed models have been va...