Influence of Si Added Hot Rolled Steel Surface Condition on Galvanizing Reaction
نویسندگان
چکیده
منابع مشابه
Statistical discriminator of surface defects on hot rolled steel
A statistical approach to defect detection and discrimination has been applied to the case of hot rolled steel. The probability distribution of pixel intensities has been estimated from a small set of images without defects, and this distribution is used to select pixels with unlikely values as candidates for defects. Discrimination of true defects from random noise pixels is achieved by a dyna...
متن کاملREACTION KINETICS OF THE FORMATION OF INTERMETALLIC Fe – Zn DURING HOT - DIP GALVANIZING OF STEEL
P. Pokorny, J. Kolisko, L. Balik – Czech Technical University – Klokner Institute, Prague, Czech Republic P. Novak – Institute of Chemical Technology, Prague, Czech Republic This review article mainly describes the composition of intermetallic Fe Zn, i.e. zeta (ζ), delta (δ1k + δ1p), gamma1 (Γ1) and gamma (Γ) on galvanized steel during low temperature galvanization (t ~ 450 °C). It gives detail...
متن کاملClassification of surface defects on hot rolled steel using adaptive learning methods
Classification of local area surface defects on hot rolled steel is a problematic task due to the variability in manifestations of the defects grouped under the same defect label. This paper discusses the use of two adaptive computing techniques, based on supervised and unsupervised learning, with a view to establishing a bask for building reliable decision support systems for classification.
متن کاملThe Influence of Surface Roughness of Drawbead on Non-Symmetry Deep Drawing Cold Rolled Steel Sheet
This study was aimed to explain the influence of surface roughness of the drawbead on non-symmetry deep drawing cold rolled steel sheet to improve the drawability of cold rolled steel sheet. The variables used in this study included semi-circle drawbead with 3 levels of surface roughness which are 6.127 μm Ra, 0.963 μm Ra and 0.152 μm Ra and cold rolled steel sheet according to 3 grades of the ...
متن کاملStabilisation of ferrite in hot rolled d-TRIP steel
A steel has recently been designed to benefit from the deformation induced transformation of retained austenite present in association with bainitic ferrite. It has as its major microstructural component, dendrites of d-ferrite introduced during solidification. The d-ferrite replaces the allotriomorphic ferrite present in conventional alloys of this kind. The authors examine here the stability ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1993
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.79.5_590