Influence of Magnetoresistance and Temperature on Permanent Magnet Condition Estimation Methods Using High-Frequency Signal Injection
نویسندگان
چکیده
منابع مشابه
Dynamic Performance Analysis of High-Frequency Signal Injection Based Sensorless Methods for Interior Permanent Magnet Synchronous Motors
This paper focuses on three commonly used sensorless methods based on high-frequency signal injection; namely, the rotating sinusoidal injection in the stationary reference frame, the pulsating sinusoidal injection in the estimated synchronous reference frame, and the pulsating square wave injection in the estimated synchronous reference frame. Although these methods have found applications in ...
متن کاملStudy on Position Polarity Compensation for Permanent Magnet Synchronous Motor Based on High Frequency Signal Injection
Abstract—The application of a high frequency signal injection method as speed and position observer in PMSM drives has been a research focus. At present, the precision of this method is nearly good as that of ten-bit encoder. But there are some questions for estimating position polarity. Based on high frequency signal injection, this paper presents a method to compensate position polarity for p...
متن کاملCombination of voltage model and high-frequency signal injection for sensorless permanent magnet synchronous motor drives
The paper proposes a method for the rotor speed and position estimation of permanent magnet synchronous motors, applicable in a wide speed range including standstill. A modified voltage model is used at high speeds, and it is combined with a high-frequency signal injection technique at low speeds. The fast dynamic response of the voltage model is thus augmented with the steady-state accuracy of...
متن کاملSensorless Control of a Permanent Magnet Syncronous Machine using Signal Injection
Today the interest for Hybrid electric vehicles (HEV) is high due to their ability to reduce the fuel consumption, which means a reduction in the operation cost as well as in the environmental impact. Weight and volume is important and the machine type with smallest size for a given performance is usually the permanently magnetized synchronous machine (PMSM). To be able to control the PMSM with...
متن کاملSensorless Model Reference Adaptive Control of DFIG by Using High Frequency Signal Injection and Fuzzy Logic Control
In this paper, a new sensorless model reference adaptive method is used for direct control of active and reactive power of the doubly fed induction generator (DFIG). In order to estimate the rotor speed, a high frequency signal injection scheme is implemented. In this study, to improve the accuracy of speed estimation, two methods are suggested. First, the coefficients of proportional-integral ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Industry Applications
سال: 2018
ISSN: 0093-9994,1939-9367
DOI: 10.1109/tia.2018.2836945