INFLUENCE OF HEAT TREATMENT ON PROPERTIES OF EN AW 6082 ALUMINIUM ALLOY
نویسندگان
چکیده
منابع مشابه
Influence of heat treatment on the microstructure and mechanical properties of 6005 and 6082 aluminium alloys
The main task of this work was to study the influence of the cooling conditions after homogenization of the 6082 aluminium alloys. The effect of the solution heat treatment temperature on the mechanism and ageing kinetics of the two commercial wrought aluminum alloys 6005 and 6082 was also analyzed. The alloys were heat treated—T4 with a wide range of solution heat treatment temperature from 51...
متن کاملInfluence of Scanning Strategies on Processing of Aluminum Alloy EN AW 2618 Using Selective Laser Melting
This paper deals with various selective laser melting (SLM) processing strategies for aluminum 2618 powder in order to get material densities and properties close to conventionally-produced, high-strength 2618 alloy. To evaluate the influence of laser scanning strategies on the resulting porosity and mechanical properties a row of experiments was done. Three types of samples were used: single-t...
متن کاملEFFECT OF SHORT HEAT TREATMENT ROUTES ON THE TRIBOLOGICAL PROPERTIES OF TI-6AL-4V ALLOY
In this research, the effect of annealing and aging temperature as well as the effect of quenching media on the microstructure, hardness and dry sliding wear behavior of Ti-6Al-4V alloy has been studied. Cylindrical samples with the diameter of 10 mm and the height of 20mm were solutionized at 930˚C and 1060˚C for 600 seconds and then were quenched in the cold water and in the air. The samples ...
متن کاملEFFECT OF T6 HEAT TREATMENT ON MECHANICAL PROPERTIES OF CERAMIC REINFORCED CASTED ALUMINUM ALLOY
Aluminium base alloy (Al-Cu-Si) was reinforced with silicon carbide (SiC) particles, in various percentage compositions from 0-20 wt%. Silicon carbide particle size of 20µm was selected. The molten slurry of SiC reinforced base aluminium metal was casted through green and dry sand casting methods and solidification process was carried out under ambient conditions. A selected population...
متن کاملStudy of microstructure and tensile properties of infrared-heat-treated cast-forged 6082 aluminum alloy
In this study, a cast rod is used as the material for the forging process (without extrusion). The cast forging process is used to ameliorate the coarse grains that form in the follow-up heating process of extrusion-forged materials. Infrared (IR) heating is also used for comparison with conventional heating processes. Experimental results show that the direct forging process (without extrusion...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Metallurgica Slovaca
سال: 2015
ISSN: 1338-1156,1335-1532
DOI: 10.12776/ams.v21i1.553