Influence of Different Contact Conditions on Friction Properties of AISI 430 Steel Sheet with Deep Drawing Quality

This article aims to investigate the influence of different contact conditions on friction properties an Nb-stabilized AISI 430 ferritic stainless-steel sheet with deep drawing quality. Three tribological tests were performed: pin-on-disk, bending under tension, and strip-tension test. Moreover, counter samples a hard metal (WC-12%Co) surface finishes 0.27 0.54 ?m used in dry lubricated conditions. The texture relative elongation strip formability also investigated. A comparative analysis results revealed that coefficients friction, wear, lubricant efficiency, hardness measured below wear indicated strong dependence roughness test type. obtained from pin-on-disk higher than those tests. In addition, coefficient increased increasing during tests; it was bending-under-tension test, mainly owing roughness. pressure non-uniform sliding tool. According our results, for each condition specific area forming die, there is value depending kinematic Therefore, can be as input data define design guidelines, improve productivity, product quality this steel sheet.