Influence of corona charging in cellular polyethylene film
نویسندگان
چکیده
منابع مشابه
Charging of moving surfaces by corona discharges sustained in air
Atmospheric pressure corona discharges are used in electrophotographic (EP) printing technologies for charging imaging surfaces such as photoconductors. A typical corona discharge consists of a wire (or wire array) biased with a few hundred volts of dc plus a few kV of ac voltage. An electric discharge is produced around the corona wire from which electrons drift towards and charge the underlyi...
متن کاملNoninvasive nature of corona charging on thermal Si/SiO2 structures
The corona charging technique is widely utilized in commercial Si/SiO2 semiconductor device reliability characterization tools and has been used in numerous electron spin resonance (ESR) experiments, by several groups to study defect centers in Si/SiO2 system. A recent ESR study argued that the corona charging approaches are inherently unreliable and invasive. In this work we show that this is ...
متن کاملViscoplastic tearing of polyethylene thin film
Recent advances in non-contact strain measurement techniques and large-strain constitutive modeling of the Linear Low-Density Polyethylene film used in NASA Superpressure balloons, StratoFilm 420, are combined to provide a novel measurement technique for the tear propagation critical value of the J-integral. Previously these measurements have required complex test configurations and procedures....
متن کاملCharge dynamic characteristics in corona-charged polytetrafluoroethylene film electrets.
In this work, the charge dynamics characteristics of injection, transport and decay in porous and non-porous polytetrafluoroethylene (PTFE) film electrets were investigated by means of corona charging, isothermal and thermal stimulating surface-potential decay measurements. The results showed that the initial surface potential, whether positively or negatively charging, is much higher in non-po...
متن کاملDetermination of percent polyethylene in polyethylene/polypropylene blends using cast film FTIR techniques
Polyethylene (PE) is the most common group of thermoplastic polymers due to its low cost and versatile physical properties. PE is blended with polypropylene (PP) to improve physical properties, such as low temperature impact performance. The composition of these blends is important with regard to performance, and the correct mixing of the pure homopolymers (PE and PP) can eliminate the need for...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2011
ISSN: 1742-6596
DOI: 10.1088/1742-6596/301/1/012054