Inductor design for high-power applications with broad-spectrum excitation
نویسندگان
چکیده
منابع مشابه
Planar Inductor Design for High Power Applications
Design, simulation, and implementation of low profile microstrip spiral inductors for high power Industrial, Scientific and Medical (ISM) applications at the high frequency (HF-3–30 MHz) range are given for the first time. An accurate analytical model and algorithm have been developed to determine the simplified lumped element equivalent model parameters for spiral inductor and its physical dim...
متن کاملDesign of a High Range, High Efficiency Spread Spectrum Transmitter for Audio Communication Applications
This work proposes a direct sequence spread spectrum transmitter with high transmission range and efficiency for audio signals. It is shown that by choosing high process gain for spread spectrum signal the data could reach a range of 55km in the 2.4GHz ISM band. By employing a light modulation scheme, we have a relaxed SNR requirement for having a low bit error rate (BER) which translates to re...
متن کاملDesign and realisation of integrated inductor with low DC-resistance value for integrated power applications
This paper presents a new topology of inductor allowing a decrease of the conductor serial resistance. After validating the concept of conductors interleaving, technological process flow and results are presented.
متن کاملDesign of phase-shifted parallel-input/series-output dual inductor-fed push-pull converter for high-power step-up applications
A new high-power step-up converter based on the phase-shifted parallel-input/series-output (PISO) modular converter with two dual inductor-fed push-pull converters is proposed. It is operated at a constant duty cycle and the output voltage is controlled with a phase-shift between the modules. It shows an output voltage which is high and linear to the control input, and a low switch turn-off str...
متن کاملDesign of a Multi-Spiral Solenoidal Inductor for Inductive Power Transfer in Biomedical Applications
Inductive power transfer is the most common method for transferring power to implantable sensors inside human body. For good inductive coupling, the inductors should have high inductance and high quality factor. But the physical dimension of the receiver inductor cannot be large due to biomedical constraints. Therefore, there is a need for small size and high inductance, high quality factor ind...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Power Electronics
سال: 1998
ISSN: 0885-8993,1941-0107
DOI: 10.1109/63.654976