Inductive voltage divider calibration with sampling method
نویسندگان
چکیده
منابع مشابه
Binary Versus Decade Inductive Voltage Divider Comparison and Error Decomposition
Absbacl-An automatic Inductive Voltage Divider ( I M ) characterization method that can measure linearity by comparing WD’s with differeut structures is suggested. Structural models are employed to decompose an error vector into components that represent each divider. Initial tests at 400 Hz show that it is possible to assign independent errors due to the binary and decade structures with a 27 ...
متن کاملA Two-stage Inductive Voltage Divider for Coaxial Bridges
The traceability chain to derive the capacitance unit from the quantum Hall resistance coaxial bridges. These bridges employ a inductive voltage divider to provide the voltage ratio needed. One such divider has recently been constructed calibrated at Inmetro. The design techniques responsible for the small ratio errors of the device are detailed
متن کاملCalibration of Multi-decade Inductive Voltage Dividers
Abstract: A method for calibrating multi-decade inductive voltage dividers has been developed which makes it possible to determine both the inphase and the quadrature error for ratios of i /11, i = 1, 2, ..., 10 in the frequency range from 400 Hz to 5 kHz. Calibration is made by comparing the divider under test against a reference two-stage divider having a ratio winding with 11 identical secti...
متن کاملInductive Voltage Transformers Calibration by the Parameters
The accuracy class of an IVT – Inductive Voltage Transformer – is typically assessed in laboratory installations either by comparing with another IVT presenting greater accuracy and traceable to a national laboratory or by using a capacitive divider. Calibration in the field using internal parameters is considered herein, using results obtained from typical open and short circuit tests and wind...
متن کاملNonlinear voltage divider
This paper is focused on how to implement a nonlinear voltage divider used in the electrical power network disturbances measurement system preconditioning circuit. The voltages acquired from the electrical power network have amplitudes between 0.2 kV and 10 kV, values which are very high for an acquisition board. These amplitudes must be reduced to the values accepted by the acquisition boards:...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: EPJ Web of Conferences
سال: 2014
ISSN: 2100-014X
DOI: 10.1051/epjconf/20147700014