Indium Tin Oxide Based Reflector for Vertical UV LEDs
نویسندگان
چکیده
منابع مشابه
Functionalization of indium tin oxide.
The preparation and functionalization of ITO surfaces has been studied using primarily X-ray photoemission spectroscopy and infrared reflection-absorption spectroscopy (IRRAS) and the reagents n-hexylamine and n-octyltrimethoxysilane (OTMS). Particular attention has been paid to characterization of the surfaces both before and after functionalization. Surfaces cleaned by ultraviolet (UV)/ozone ...
متن کاملIndium Tin Oxide@Carbon Core–Shell Nanowire and Jagged Indium Tin Oxide Nanowire
This paper reports two new indium tin oxide (ITO)-based nanostructures, namely ITO@carbon core-shell nanowire and jagged ITO nanowire. The ITO@carbon core-shell nanowires (~50 nm in diameter, 1-5 μm in length,) were prepared by a chemical vapor deposition process from commercial ITO nanoparticles. A carbon overlayer (~5-10 in thickness) was observed around ITO nanowire core, which was in situ f...
متن کاملOptoelectric biosensor using indium-tin-oxide electrodes.
The use of an optically thin indium-tin-oxide (ITO) electrode is presented for an optoelectric biosensor simultaneously recording optical images and microimpedance to examine time-dependent cellular growth. The transmittance of a 100 nm thick ITO electrode layer is approximately the same as the transmittance of a clean glass substrate, whereas the industry-standard Au(47.5 nm)/Ti(2.5 nm) electr...
متن کاملHydrogen-doped indium oxide/indium tin oxide bilayers for high-efficiency silicon heterojunction solar cells
The front transparent conductive oxide layer is a source of significant optical and electrical losses in silicon heterojunction solar cells because of the trade-off between free-carrier absorption and sheet resistance. We demonstrate that hydrogen-doped indium oxide (IO:H), which has an electron mobility of over 100 cm/V s, reduces these losses compared to traditional, low-mobility transparent ...
متن کاملIndium Tin Oxide Nanowire Networks as Effective UV/Vis Photodetection Platforms
We demonstrate that indium tin oxide nanowires (ITO NWs) and cationic polymer-modified ITO NWs configured in a network format can be used as high performing UV/vis photodetectors. The photovoltage response of ITO NWs is much higher than similarly constructed devices made from tin oxide, zinc tin oxide, and zinc oxide nanostructures. The ITO NW mesh-based devices exhibit a substantial photovolta...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Korean Journal of Materials Research
سال: 2013
ISSN: 1225-0562
DOI: 10.3740/mrsk.2013.23.3.194