منابع مشابه
Ultrasonic assisted-ECAP.
Equal channel angular pressing (ECAP) is one of the most prominent procedures for achieving ultra-fine grain (UFG) structures among the various severe plastic deformation (SPD) techniques. In this study, the effect of ultrasonic vibration on deformation behavior of commercial pure aluminum in the ECAP process is analyzed successfully using three dimensional (3D) by finite element methods (FEMs)...
متن کاملConverging Hands or Converging Minds?
Interlocutors sometimes repeat each other’s representational hand gestures. We investigated if this is a case of direct mimicry of form, or whether perceiving a gesture gives rise to a semantic representation, which subsequently informs gesture production. For this we used an interactive route description task, in which a confederate’s gestures indicated the route in either the vertical or the ...
متن کاملPrediction of optimal operating parameters for continuous casting of billets
Process optimization determines process parameters that maximize or minimize (optimize) so aspect of a process (the obieciive function), while ensuring that the process operates wr established limits. In this work a mathematical model that simulates heat flow and solidification continuously cast steel strand is coupled with mathematical optimization techniques to predict opt process parameters ...
متن کاملInduction heating of aluminium billets using superconducting coils
It is proposed to apply high-temperature superconducting (HTS) tape in the coil windings for induction heaters for aluminium or copper extrusion billets. The potential for efficiency improvements is substantial, as conventional copper coil induction heaters rated for up to around 1 MW operate with an overall efficiency of typically only 50–60%. The efficiency of a HTS induction heater depends v...
متن کاملMicrostructure of Ultrafine- Grained Metals after Ecap
This paper was aimed at verification of functionality of the ECAP technology at extrusion of the copper, alluminium alloys and steel. Experiments were made on equipment, which is demonstrated in the Fig 1. Deformation forces were measured during extrusion, resistance to deformation was calculated and deformation speed was determined approximately. Analysis of structure was made with use of ligh...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Key Engineering Materials
سال: 2013
ISSN: 1662-9795
DOI: 10.4028/www.scientific.net/kem.554-557.869