Increasing Surface Hardness of AISI 1045 Steel by AIH-FPP/Plasma Nitriding Treatment
نویسندگان
چکیده
منابع مشابه
Duplex Surface Treatment of AISI 1045 Steel via Plasma Nitriding of Titanized Layer
In this Study, surface of medium carbon steel (AISI 1045) was modified by titanizing followed by plasma nitriding. Titanizing was performed using pack cementation method, in a pack mixture of ferrotitanium, ammonium chloride and alumina, at 1223 K for 45 and 180 min. Plasma-nitriding was conducted at two temperatures of 803 and 823 K for 5 h, in a gas mixture of 75%N2+25%H2. The samples were c...
متن کاملSurface Texturing-Plasma Nitriding Duplex Treatment for Improving Tribological Performance of AISI 316 Stainless Steel
Surface texturing-plasma nitriding duplex treatment was conducted on AISI 316 stainless steel to improve its tribological performance. Tribological behaviors of ground 316 substrates, plasma-nitrided 316 (PN-316), surface-textured 316 (ST-316), and duplex-treated 316 (DT-316) in air and under grease lubrication were investigated using a pin-on-disc rotary tribometer against counterparts of high...
متن کاملExpansion and fracture of AISI 1045 steel explosive-filled cylinders
By a improved front light-source framing photography technique and a simple fragments soft recovered method, the expansion and fracture behaviour of the AISI 1045 steel cylinders loaded by three different brisance explosives have been studied . Cylinders were heat treated-normalized and quenched and tempered. Experimental results show that the more intensive of the loading ,the stronger capabil...
متن کاملMechanical Properties of Boronized AISI 316, AISI 1040, AISI 1045 and AISI 4140 Steels
In this study, some mechanical properties of borided and unborided four steels were investigated. Boronizing of steels was performed by powder pack method at 1210 K for 4 h. The hardness of borides, boride layer thickness and room temperature tensile properties were measured and it was observed that hardness and tensile properties strongly depend on chemical composition of steels. In addition, ...
متن کاملApplication of Response Surface Methodology For Determining MRR and TWR Model In Die Sinking EDM of AISI 1045 Steel
Whereas the efficiency of traditional cutting processes is limited by the mechanical properties of the processed material and the complexity of the workpiece geometry, electrical discharge machining (EDM) being a thermal erosion process, is subject to no such constraints. The base material used for this study was an AISI 1045 steel with copper electrode. This study highlights the development of...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATERIALS TRANSACTIONS
سال: 2013
ISSN: 1345-9678,1347-5320
DOI: 10.2320/matertrans.mbw201205