In situ resin age assessment using dielectric analysis and resin cure map for efficient vacuum infusion
نویسندگان
چکیده
منابع مشابه
Stereolithography Cure Process Modeling Using Acrylate Resin
Yanyan Tang†, Clifford L. Henderson†, John Muzzy†, David W. Rosen* † School of Chemical & Biomolecular Engineering, 311 Ferst Drive, N.W., Georgia Institute of Technology, Atlanta, GA 30332-0100 *Corresponding author; School of Mechanical Engineering, 813 Ferst Drive, N.W., Georgia Institute of Technology, Atlanta, GA 30332-0405; Email: [email protected] Reviewed, accepted September 1, ...
متن کاملInvestigation of Parameters Effect Resin Movement Velocity at Vacuum Assisted Resin Transfer Molding Method (VARTM)
In this paper, Vacuum Assisted Resin Transfer Molding (VARTM) method was simulated by analytical solution. Then the effect of parameters like fiber density, distribution of layer thickness, perform layer thickness, resin viscosity was investigated theoretically. Obtained results show that by selecting optimum distribution layer thickness, increasing fiber volume fraction, reducing viscosity of ...
متن کاملManufacturing of polymer matrix composites using vacuum assisted resin infusion molding
Purpose: The purpose of the paper is to manufacture the polymer matrix composites using vacuum assisted resin infusion molding. Design/methodology/approach: Electrical heating resistances are used for heating of table. The temperature control is achieved by means of acquiring temperatures using thermocouples located beneath the table surface. VARIM table is divided into eight regions. Each regi...
متن کاملpreparation and characterization of new co-fe and fe-mn nano catalysts using resol phenolic resin and response surface methodology study for fischer-tropsch synthesis
کاتالیزورهای co-fe-resol/sio2و fe-mn-resol/sio2 با استفاده از روش ساده و ارزان قیمت همرسوبی تهیه شدند. از رزین پلیمری resol در فرآیند تهیه کاتالیزور استفاده شد.
Resin Flow Behavior Simulation of Grooved Foam Sandwich Composites with the Vacuum Assisted Resin Infusion (VARI) Molding Process
The resin flow behavior in the vacuum assisted resin infusion molding process (VARI) of foam sandwich composites was studied by both visualization flow experiments and computer simulation. Both experimental and simulation results show that: the distribution medium (DM) leads to a shorter molding filling time in grooved foam sandwich composites via the VARI process, and the mold filling time is ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advanced Manufacturing: Polymer & Composites Science
سال: 2020
ISSN: 2055-0340,2055-0359
DOI: 10.1080/20550340.2020.1834790