In-process measurement of friction coefficient in orthogonal cutting
نویسندگان
چکیده
منابع مشابه
Investigation of Friction Coefficient Effects on Fishtail Defect in Hot Ring Rolling Process
Hot ring rolling is a highly nonlinear, unsteady-state and asymmetry process which is affected by many parameters. The friction coefficient between the ring ,the driver roll and the idle roll is one of the problems, which has significant effect on the quality of final product. In this study, the effect of these two parameters on hot ring rolling was investigated based on a 3D coupled-thermo mec...
متن کاملMeasurement of the coefficient of friction of floors
An improved method of measuring the coefficient of sliding friction of floor products is described, whereby similar measurements are made on laboratory samples and floors. An average value over the surface and a trace showing the local variations in friction across the surface are obtained. The latter facilitates studies of the efficiency of geometric projections and other surface effects that ...
متن کاملEstimation of Friction Coefficient in Sediment Contained Flow through Rockfill
An increase in the flow velocity in flowthrough large porous media and deflection of flow regime from Darcy law causes a nonlinear relationship between hydraulic gradient and pore velocity of media. So many investigations have done previously in such Medias. One of the most important subjects in flowthrough large porous media is relationship between friction coefficient and flow characteristics...
متن کاملDynamic Friction Coefficient Measurement of Granular Fertiliser Particles
T.E. Grift; G. Kweon; J.W. Hofstee; E. Piron; S. Villette Department of Agricultural and Biological Engineering, University of Illinois, Urbana IL, USA; e-mail of corresponding author: [email protected] Wageningen University and Research Centre, Wageningen, The Netherlands; e-mail: [email protected] Agricultural and Environmental Engineering Research Institute (CEMAGREF), Montoldre, France;...
متن کاملResidual Stresses in Orthogonal Cutting of Metals: the Effect of Thermomechanical Coupling Parameters and of Friction
M. H. Miguélez1, R. Zaera2, A. Molinari3, R. Cheriguene1, and A. Rusinek4 Department of Mechanical Engineering, Universidad Carlos III, Leganés, Madrid, Spain Department of Continuum Mechanics and Structural Analysis, Universidad Carlos III de Madrid, Leganés, Madrid, Spain Laboratory of Physics and Mechanics of Materials, Université Paul Verlaine-Metz, Metz cedex, France National Engineering S...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: CIRP Annals
سال: 2014
ISSN: 0007-8506
DOI: 10.1016/j.cirp.2014.03.083