In-mould gel-coating for polymer composites
نویسندگان
چکیده
منابع مشابه
In-mould Gel Coating for Resin Transfer Moulding
Fibre-reinforced polymer matrix composites find use in most transport applications, chemical plant, renewable energy systems, pipelines and a variety of other industries. Many of these applications require a separate surface finish for cosmetic and/or durability reasons. This coating, known as the gel-coat, is normally applied onto the mould tool before the structural laminate is moulded agains...
متن کاملPolymer Composites for Bone Reconstruction
The need for reconstructive surgery of bones is continuously increasing along with the ageing of the population as well as the increase of traumatologic injuries. In the United States, the number of bone grafts was 350,000 in 2001. Nowadays, over 500,000 bone graft procedures are performed annually, and approximately 2.2 million worldwide (Giannoudis et al., 2005). The estimated cost of these p...
متن کاملTio2 Coating by Gel Oxidation
Gel oxidation is a thermochemical method for the production of an oxide film on a metallic substrate, where the metallic substrate is subjected to gelation by immersion in NaOH solution, followed by oxidation.These films are prepared for biomedical implant coating. Continuous and discontinuous gelled and TiO2 films of submicron thickness were produced on high-purity Ti foil substrates (50μm thi...
متن کاملMagnetic Gel Composites for Hyperthermia Cancer Therapy
Hyperthermia therapy is a medical treatment based on the exposition of body tissue to slightly higher temperatures than physiological (i.e., between 41 and 46 °C) to damage and kill cancer cells or to make them more susceptible to the effects of radiation and anti-cancer drugs. Among several methods suitable for heating tumor areas, magnetic hyperthermia involves the introduction of magnetic mi...
متن کاملpolymer utilization in sugar beet seed coating
this study aimed at determining the effect of domestic synthesized polymer on germination and growth of sugar beet seedling in laboratory, greenhouse, and field. the study was conducted based on randomized complete block design with four replications at sugar beet seed institute, karaj, iran in 2010-2012. the treatments were uncoated (control) and coated seed with foreign polymer, and also seve...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Composites Part A: Applied Science and Manufacturing
سال: 2016
ISSN: 1359-835X
DOI: 10.1016/j.compositesa.2016.10.014