Improvement of high temperature heat exchanger efficiency by inserted porous material, (II) Preheating, single tube type shell and tube heat exchanger.
نویسندگان
چکیده
منابع مشابه
Effect of baffle oientation on shell tube heat exchanger performance
In this paper, fluid flow and heat transfer in the laboratory (small size) shell tube heat exchanger are analysed by computational fluid dynamic software. In this type of shell tube heat exchanger baffles with different angles of rotation: 00 (horizontal segmental baffle), 150 (from horizontal), 300, 450, 600, 750, 900 (vertical segmental baffle) is used. Effect of baffle orientation on shell t...
متن کاملTwisted Tube Heat Exchanger Technology
Over 85% of all new heat exchanger applications in oil refining, chemical, petro-chemical, and power generation are accommodated through the use of conventional shell and tube type heat exchangers. The fundamental basis for this statistic is shell and tube technology is a cost effective, proven solution for a wide variety of heat transfer requirements. However, there are limitations associated ...
متن کاملEconomic Optimization of Shell and Tube Heat Exchanger Using Nanofluid
Economic optimization of shell and tube heat exchanger (STHE) is presented in this paper. To increase the rate of heat transfer, copper oxide (CuO) nanoparticle is added into the tube side fluid and their optimum results are compared with the case of without additive nanoparticle. Total annual cost (TAC) is selected as fitness function and nine decision variables related to the heat exchanger p...
متن کاملNonlinear Control Of A Shell And Tube Heat Exchanger
The paper deals with design and simulation of nonlinear adaptive control of a shell and tube heat exchanger. The method is based on factorization of the controller on a nonlinear static part and an adaptive linear dynamic part. The nonlinear static part is derived using inversion and subsequent exponential approximation of simulated or measured steady-state characteristics of the exchanger. The...
متن کاملInvestigating Tubes Material Selection on Thermal Stress in Shell Side Inlet Zone of a Vertical Shell and Tube Heat Exchanger
In this study, the effect of the tube material on the thermal stress generated in a vertical shell and tube heat exchanger is investigated. Shell and tube heat exchangers are the most common heat exchangers used in industries. One of the most common failures in these exchangers in the industry is the tube failure at the junction of the tube to tubesheet. When the shell side and the tube side fl...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Atomic Energy Society of Japan / Atomic Energy Society of Japan
سال: 1985
ISSN: 0004-7120
DOI: 10.3327/jaesj.27.243