Improvement of Fatigue Strength by Two-Step Aging in Beta Ti-22V-4Al Alloy.
نویسندگان
چکیده
منابع مشابه
Surface modification of Ti-4Al-2V alloy by nitrogen implantation
Ti-4Al-2V is a new type of alpha titanium alloy that suitable for the application in high-temperature and high-pressure water/steam environment. Ti-4Al-2V can be used in marine engineering, nuclear power industry. In this paper the surface characterization of the Ti-4Al-2V implanted with 75 keV nitrogen with fluences of 3 × 1017 and 8 × 1017 N+/cm2 is investigated by glancing-incidence XRD, XPS...
متن کاملFatigue and corrosion fatigue properties of Ti-6Al-4V implant grade titanium alloy in Ringer solution
Nowadays modification of metallic biomaterials which are used as implants for bone and hard tissues replacement is considered as an important subject. In the current study, corrosion fatigue properties of Ti-6Al-4V alloy investigated via Rotating-Bending standard test method and then, the results compared with the fatigue properties of the specimens tested in the same conditions. Scanning elect...
متن کاملTensile and fatigue strength of hydrogen-treated Ti-6Al-4V alloy
Tensile, fatigue and fractographic data on Ti-6AI-4V microstructures attained through a series of post-L3-annealing treatments which used hydrogen as a temporary alloying element are presented. Hydrogen-alloying treatments break up the continuous grain boundary 0c and colony structure, and produce a homogeneous microstructure consisting of refined s-grains in a matrix of discontinuous 13. These...
متن کاملFatigue properties of Ni-43.5%Ti superelastic alloy castings.
To evaluate a Ni-43.5wt%Ti alloy as a new alloy for cast clasp, the fatigue properties of its castings were examined and compared with those of Co-Cr and Type IV Au alloys castings. The Ni-Ti alloy was cast into a phosphate-bonded investment mold using an argon-arc melting and pressure casting machine. The Ni-Ti alloy castings showed superelasticity in bending tests. Fatigue tests were carried ...
متن کاملCeramic bonding strength of Au-1.6 wt% Ti alloy.
The aim of this investigation was to evaluate the metal-ceramic bonding of Au-1.6 wt% Ti alloy. Therefore, the coefficient of thermal expansion, modulus of elasticity, ceramic bonding strength, and hardness of Au-1.6 wt% Ti alloy were measured. The metal-ceramic interface was observed by EPMA to investigate its bonding mechanism. The Au-1.6 wt% Ti alloy showed a coefficient of thermal expansion...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 2001
ISSN: 1880-7488,0514-5163
DOI: 10.2472/jsms.50.151