Improvement of Fatigue Properties by Means of Continuous Cyclic Bending and Annealing in an Al-Mg-Mn Alloy Sheet
نویسندگان
چکیده
منابع مشابه
Stored Energy and Taylor Factor Relation in an Al-Mg-Mn Alloy Sheet Worked by Continuous Cyclic Bending
The relation between the stored energy and the Taylor factor (TF) has been investigated using the SEM/EBSP analysis in an Al-Mg-Mn alloy sheet worked by the continuous cyclic bending (CCB). The analysis reveals that the stored energy is high for the high TF region, whereas a significant increase of the stored energy with the decrease of the Taylor factor appears in the vicinity of the minimum T...
متن کاملCrystallographic Orientation Distribution Control by Means of Continuous Cyclic Bending in a Pure Aluminum Sheet
Continuous cyclic bending (CCB) has been proposed as a useful straining technique to produce the high strain on the surface layers and the lower strain in the central layer of the sheet. A pure aluminum sheet is worked by the CCB using the ‘‘Roll traveling device’’ and ‘‘Roll driven machine’’. It is found that a sharp Cube orientation is formed by the CCB and subsequent annealing in the pure al...
متن کاملcontrol of the optical properties of nanoparticles by laser fields
در این پایان نامه، درهمتنیدگی بین یک سیستم نقطه کوانتومی دوگانه(مولکول نقطه کوانتومی) و میدان مورد مطالعه قرار گرفته است. از آنتروپی ون نیومن به عنوان ابزاری برای بررسی درهمتنیدگی بین اتم و میدان استفاده شده و تاثیر پارامترهای مختلف، نظیر تونل زنی(که توسط تغییر ولتاژ ایجاد می شود)، شدت میدان و نسبت دو گسیل خودبخودی بر رفتار درجه درهمتنیدگی سیستم بررسی شده اشت.با تغییر هر یک از این پارامترها، در...
15 صفحه اولFatigue Behavior of an Ultrafine-Grained Al-Mg-Si Alloy Processed by High-Pressure Torsion
The paper presents the evaluation of the mechanical and fatigue properties of an ultrafine-grained (UFG) Al 6061 alloy processed by high-pressure torsion (HPT) at room temperature (RT). A comparison is made between the UFG state and the coarse-grained (CG) one subjected to the conventional aging treatment Т6. It is shown that HPT processing leads to the formation of the UFG microstructure with ...
متن کاملDsc Study of Precipitation in an Al-mg-mn Alloy Microalloyed with Cu
Power compensation DSC has been employed to detect and analyse precipitation reactions in an Al1.3Mg-0.4Mn and an Al-1.3Mg-0.4Mn-0.07Cu alloy in which very small amounts of precipitate, less than 0.3 at%, are expected to form. Due to the very small heat effects, baseline instability and drift significantly interfere with the measurements. After repeated experiments and careful baseline correcti...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATERIALS TRANSACTIONS
سال: 2004
ISSN: 1345-9678,1347-5320
DOI: 10.2320/matertrans.45.1833