Implementation on a Preparation and Controlled Compaction Procedure for Waste-Fiber-Reinforced Raw Earth Samples

نویسندگان

چکیده

Earth bricks are a traditional eco-friendly construction material. In this study, harbor-dredged sediments were used along with hemp shiv to develop brick manufacturing procedure and compaction techniques produce durable earth for the valorization of waste dredged sediments. Prismatic specimens size 4 × 16 cm3 manufactured Dunkirk after analyzing their suitability according French standard flexural strength test observe indirect tensile impact on bricks. Crude varying content from 0% 5% by mass. Compaction such as dynamic compaction, static tamping applied. The effect was evaluated distribution fibers in Grain analysis Spanish standards shows that granulometry is suitable testing indicates saturated have higher strength. maximum 1% shiv, which satisfies adobe requirements vary 0.012 0.025 MPa (NZS 4298, 1998; NORMA E.080 (2017).

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A Procedure for Preparation of Semi-activated Carbon Fiber without any Treatment under High Temperature

A procedure for preparation of semi-activated carbon fiber (SACF) without any treatment under high temperature was proposed. The first step of the procedure is coating of an inorganic fiber (E-glass fiber) by an adsorbent mixture including powder activated carbon, methyl cellulose and water. In this work a set of experiments was performed to attain appropriate adsorbent mixture for good quality...

متن کامل

A fiber-reinforced Transversely Isotropic Constitutive Model for Liver Tissue

Biomechanical properties of soft tissue, such as liver, are important in modeling computer aided surgical procedures. Experimental evidences show that liver tissue is transversely isotropic. In this article, considering the liver tissue as an incompressible fiber-reinforced composite with one family of fibers, an exponential strain energy function (SEF) is proposed. The proposed SEF is based on...

متن کامل

Design and Application of a Fiber Pullout Test for Examining Controlled Interfaces in Fiber Reinforced Polymers

page 62 Abstract: A fiber pullout test for examining controlled interfaces in fiber reinforced polymers has been designed and demonstrated. This test has been utilized in determining interfacial fracture toughness for sapphire/epoxy single fiber composite specimens. Some of these specimens incorporated a self-assembled monolayer at the sapphire/ epoxy interface as a means of adhesion control—th...

متن کامل

Fiber- Reinforced Composite for Orthodontic Anchorage Technique

Introduction: In orthodontic treatment, adequate anchorage is necessary to move the intended teeth. In some cases, just anterior teeth are malaligned, while posterior occlusion is acceptable. Therefore, the posterior teeth could be integrated by fiber-reinforced composite (FRC) to provide a rigid anchorage. This method proved advantageous since brackets are bonded just to anter...

متن کامل

Technical note: a procedure for the preparation and quantitative analysis of samples for titanium dioxide.

A procedure was developed for the rapid analysis of titanium dioxide (TiO2) concentrations in feed and fecal samples. Samples were digested in concentrated H2SO4 for 2 h, followed by addition of 30% H2O2, and absorbance was measured at 410 nm. Standards were prepared by spiking blanks with increasing amounts of TiO2, resulting in a linear standard curve. Complete analysis using this procedure c...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of composites science

سال: 2021

ISSN: ['2504-477X']

DOI: https://doi.org/10.3390/jcs6010003