Impact of Solar Photovoltaic System on Transformer Tap Changer in Low Voltage Distribution Networks
نویسندگان
چکیده
منابع مشابه
Effect of Solid-State on Load Distribution Transformer Tap-Changer on Power Quality Enhancement
Recently electronic tap-changer has received more attention due to its quick response, better performance and simpler maintenance compared to the mechanical tap-changer. This paper presents the capability of the distribution transformer equipped with an electronic tap-changer for improving power quality. At this end, the analytical computation for determining the compensating limit of electroni...
متن کاملSolid - State On Load Tap - Changer for Transformer Using Microcontroller
The on-load tap changing (OLTC) regulators have been widely used since the introduction of electrical energy. They ensure a good regulation of the output voltage in presence of large variations of the input voltage with typical response time from several mili-seconds to several seconds. Earlier mechanical type of on load tap changers were into practice. But they had considerable limitations and...
متن کاملOn-Line Independent Tap-Changing of Each Feeder Supplied by a Low Voltage Distribution Transformer
An on-line tap-changing circuit was developed for use with low voltage transformers (10 kV/380 V, or equivalent), in which the tap positions could be set independently for each low voltage feeder. This allows for possible variation in loads and distributed generation between different feeders fed from a given transformer, allowing the line voltages to be kept within limits on all feeders. A com...
متن کاملInnovative Transformer Load Tap Changer Control Using Ethernet-Based Communications
This paper describes the design of a load tap changer (LTC) control for up to four parallel transformers using a modified circulating current approach. The LTC control discussed in this paper was implemented using programmable logic, math functions, and IEC 61850 communications over fiber-optic Ethernet. One LTC control is associated with each transformer. The current angle from each LTC contro...
متن کاملMulti-objective Based Optimization Using Tap Setting Transformer, DG and Capacitor Placement in Distribution Networks
In this article, a multi-objective function for placement of Distributed Generation (DG) and capacitors with thetap setting of Under Load Tap Changer (ULTC) Transformer is introduced. Most of the recent articles have paidless attention to DG, capacitor placement and ULTC effects in the distribution network simultaneously. Insimulations, a comparison between different modes was carried out with,...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Energy Procedia
سال: 2016
ISSN: 1876-6102
DOI: 10.1016/j.egypro.2016.11.249