Impact of DFIG‐based wind turbine's fault current on distance relay during symmetrical faults
نویسندگان
چکیده
منابع مشابه
Fault Behavior of Wind Turbines
Synchronous generators have always been the dominant generation type in the grid. This fact affected both planning and operation of power systems. With the fast increase of wind power share in the grid in the last decade, the situation is changing. In some countries wind power represents already a consistent amount of the total generation. Wind turbines can be classified as non-synchronous gene...
متن کاملA fault detection method for pitch actuators faults in wind turbines
The paper presents a model-based fault detection method for pitch actuators faults using the normalized gradient method to estimate the parameters of the pitch actuator. One major difficulty is that the input signal to the parametric estimation method must be a persistent excitation. To circumvent this, a chattering term is added to the pitch control law and the usual low-pass filters are not u...
متن کاملFrequency Based Fault Detection in Wind Turbines
In order to obtain lower cost of energy for wind turbines fault detection and accommodation is important. Expensive condition monitoring systems are often used to monitor the condition of rotating and vibrating system parts. One example is the gearbox in a wind turbine. This system is operated in parallel to the control system, using different computers and additional often expensive sensors. I...
متن کاملSensor Fault Diagnosis of Wind Turbines for Fault Tolerant
This paper aims at the blade root moment sensor fault detection and isolation issue. The underlying problem is crucial to the successful application of the individual pitch control system which plays a key role for reducing the blade loads of large offshore wind turbines. In this paper, a wind turbine model is built based on the closed loop identification technique, where the wind dynamics is i...
متن کاملObserver Based Detection of Sensor Faults In Wind Turbines
An observer based scheme is proposed to detect sensor faults in wind turbines. In the example used for the proposed scheme the wind turbine drive train is considered. A model of the drive train is used to design the observer, and in this model the wind speed is an important input, however, if an unknown input observer the fault detection scheme can be non dependent on the actual wind speed. The...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IET Renewable Power Generation
سال: 2020
ISSN: 1752-1416,1752-1424
DOI: 10.1049/iet-rpg.2020.0435