Image artifacts caused by incorrect bowtie filters in cone‐beam CT image‐guided radiotherapy

Filtration artifacts caused by overloading membrane filters.

The conventional practice of using 0.45 or 0.40 microm membranes to distinguish between the particulate and dissolved phases in natural waters neglects the importance of colloids. Many of the colloids in natural waters pass through 0.45 or 0.40 microm membranes, but a significant fraction at the upper end of the colloidal particle size range is retained. Membrane clogging during filtration decr...

Forming Mechanism and Correction of CT Image Artifacts Caused by the Errors of Three System Parameters

We know that three system parameters, a center of X-ray source, an isocenter, and a center of linear detectors, are very difficult to be calibrated in industrial CT system. So there are often the offset of an isocenter and the deflection of linear detectors. When still using the FBP (filtered backprojection) algorithm under this condition, CT image artifacts will happen and then can seriously a...

Reduction of CT artifacts caused by metallic implants.

A technique to reduce metallic implant artifacts on computed tomography scans is presented. The implant boundaries are determined semiautomatically; the missing projection data are replaced by linear interpolation. The complete procedure requires 1-2 minutes per scan. Images with greatly improved quality were obtained in the presence of surgical clips and pelvic implants; success is limited in ...

Common Image Artifacts in Cone Beam CT

stimate bowtie filter shape in PET/CT scan with TLD

Introduction: The CT machine utilizes a bowtie filter to shape the X-ray beam and remove lower energy photons. Configuration of this bowtie filter is complex and its geometry is often not available in detail. It causes the CT dose index (CTDI) be with the different values in measurement versus Monte Carlo simulation studies and other analytical calculations. It is important esp...