Identification of potential fungal degraders of low-density polyethylene (LDPE)
نویسندگان
چکیده
منابع مشابه
Thermal-insulation performance of low density polyethylene (LDPE) foams: Comparison between two radiation thermal conductivity models
The loss of energy especially in industrial and residential buildings is one of the main reasons of increased energy consumption. Improving the thermal insulation properties of materials is a fundamental method for reducing the energy losses. Polymeric foams are introduced as materials with excellent thermal insulation properties for this purpose. In the present study, a deep theoretical invest...
متن کاملOptimization of Injection Moulding Process Parameters in the Moulding of Low Density Polyethylene (LDPE)
Injection moulding is one of the most popular polymer processing methods due to its high production rate as well as its ability to produce very intricate geometries at very cheaper cost and within few seconds. There are several flaws which occur while producing plastic parts by Injection moulding, like warpage, shrinkage, flash, sink marks etc. Shrinkage is one of the most critical problems whi...
متن کاملModeling and Simulation of Low Density Polyethylene (LDPE) High Pressure Tubular Reactor
Low Density Polyethylene (LDPE) is produced by free radical polymerization. Industrially, LDPE polymerization process is usually carried out in a continuous mode (tubular or autoclave reactors) at high pressures (1300-3400 atm) and temperatures (50-340 0 C). LDPE exhibits a number of desirable properties, including high tensile strength, flexibility, high impact resistance, low crystallinity, l...
متن کاملGrafting of Acrylamide to Low Density Polyethylene During Melt Processing
Acrylamide was grafted in low density polyethylene during melt processing in the presence of a free radical initiator using a torque rheometer in a closed system. Effects of processing time, acrylamide and benzoyl peroxide concentrations were studied. FTIR studies revealed that the degree of grafting increased by an increase in acrylamide concentration. Maximum grafting was obtained at 7 mi...
متن کاملCatalytic conversion of waste low density polyethylene into fuel oil
Waste Low density polyethylenes (LDPE) represent a source of energy and valuablechemicals, were pyrolysed catalytically in a batch reactor under atmospheric pressure. Calciumcarbide was used as a catalyst to explore its effect on pyrolysis product distribution. The effect oftemperature, amount of catalyst and time on the yields of the pyrolysed products wasinvestigated. The effect of catalyst o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Science
سال: 2019
ISSN: 2602-9030,1391-586X
DOI: 10.4038/jsc.v10i2.20