IDENTIFICATION OF LAYERS DISTRIBUTION IN THE COMPOSITE COUPON USING FINITE ELEMENT METHOD AND THREE POINT BENDING TEST
نویسندگان
چکیده
منابع مشابه
buckling of viscoelastic composite plates using the finite strip method
در سال های اخیر، تقاضای استفاده از تئوری خطی ویسکوالاستیسیته بیشتر شده است. با افزایش استفاده از کامپوزیت های پیشرفته در صنایع هوایی و همچنین استفاده روزافزون از مواد پلیمری، اهمیت روش های دقیق طراحی و تحلیل چنین ساختارهایی بیشتر شده است. این مواد جدید از خودشان رفتارهای مکانیکی ارائه می دهند که با تئوری های الاستیسیته و ویسکوزیته، نمی توان آن ها را توصیف کرد. این مواد، خواص ویسکوالاستیک دارند....
Using the Finite Element Analysis Method to Study the 3-point Bending Test for the Characterization of the Adherence
An elastic finite element analysis was conducted to evaluate the stress distribution in the initiation zone of the adhesive rupture during the 3-point bending test. This test is used to measure the adherence between a polyepoxy adhesive and aluminum alloy with different surface treatments. The purpose is to compare, in the high stress concentration areas, the stress fields calculated using fini...
متن کاملCorrecting the stress-strain curve in hot compression test using finite element analysis and Taguchi method
In the hot compression test friction has a detrimental influence on the flow stress through the process and therefore, correcting the deformation curve for real behavior is very important for both researchers and engineers. In this study, a series of compression tests were simulated using Abaqus software. In this study, it has been employed the Taguchi method to design experiments by the factor...
متن کاملFree vibration analysisof soft-core composite-faced sandwich plates using three-dimensional finite element method
In this paper, natural frequencies of the sandwich plates with soft flexible core and composite face sheets are obtained. Three-Dimensional (3D) finite element method (FEM) is used for constructing and analyzing of the sandwich plates to obtain their natural frequencies. Continuity conditions for transverse shear stresses at the interfaces as well as transverse flexibility and transverse normal...
متن کاملUsing Finite Element Software to Simulation Fracture Behavior of Three-point Bending Beam with Initial Crack
using computation software to simulate fracture behaviors of structures can shorten the time to estimate safety of engineering structures and reduce a lot of cost of experiment. However three dimensional numerical simulation for fracture process is a challenging issue, because the convergence and accuracy are not easily obtained and high computational cost is generated. In this paper, three new...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Mechanica et Automatica
سال: 2013
ISSN: 2300-5319
DOI: 10.2478/ama-2013-0027