Identification of induction machine parameters using only no-load test measurements
نویسندگان
چکیده
منابع مشابه
Simple mechanical parameters identification of induction machine using voltage sensor only
A simple low cost algorithm for induction motor mechanical parameters estimation without speed sensor is presented in this paper. Estimation is carried out by recording stator terminal voltage during natural braking and subsequent offline curve fitting. The algorithm allows accurately reconstructing mechanical time constant as well as loading torque speed dependency. Although the mathematical b...
متن کاملPermanent Magnet Synchronous Machine Parameters Identification for Load Characteristics Calculation
Self reactanceXd in direct axis ’d’ and self reactanceXq in quadrature axis ’q’ influence the load characteristics of the permanent magnet machine. Their calculation methods are known. All calculations should be verified by measurements. Measurement with AC variable voltage and frequency source applied on stator winding is correct when eddy currents do not exist. Other methods evaluate the DC c...
متن کاملIdentification of induction motor parameters from transient stator current measurements
This paper describes three methods for estimating the lumped model parameters of an induction motor using startup transient data. A three-phase balanced induction motor is assumed. Measurements of the stator currents and voltages are required for the identification procedure, but no measurements from the motor shaft are needed. The first method presented applies simple models with limited tempo...
متن کاملOn the Identification of the Synchronous Machine Parameters Using Standstill DC Decay Test
Usually, the characteristic values of a synchronous machine are obtained from a short-circuit test at no-load. This test requires substantial equipment and is therefore expensive, it implies risks and it can not be always carried out for levels of voltage higher than 50% to 60% of nominal voltage. This DC decay test is an interesting alternative since only light equipment is needed. It delivers...
متن کاملInduction Motor Electric Parameters Estimation Using Artificial Neural Networkds and its Application in industrial Load Modeling
Load modeling is widely used in power system studies. Two types of modeling, namely, static and dynamic, are employed. The current industrial practice is the static modeling. Static modelss are algebraic equations of active and reactive power changes in terms of voltage and frequency deviations. In this paper, a component based on static modeling is employed in which the aggregate model is deri...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nigerian Journal of Technology
سال: 2018
ISSN: 2467-8821,0331-8443
DOI: 10.4314/njt.v37i3.25