HYSIM: Hybrid Fault Simulation for Synchronous Sequential Circuits
نویسندگان
چکیده
منابع مشابه
Hybrid Fault Simulation for Synchronous Sequential Circuits 1
We present a fault simulator for synchronous sequential circuits that combines the eeciency of three-valued logic simulation with the exactness of a symbolic approach. The simulator is hybrid in the sense that three diierent modes of operation-three-valued, symbolic and mixed-are supported. We demonstrate how an automatic switching between the modes depending on the computational resources and ...
متن کاملDiagnostic fault simulation for synchronous sequential circuits
In this paper, a time and memory-efficient diagnostic fault simulator for sequential circuits is first presented. A distributed diagnostic fault simulator is then presented based on the sequential algorithm to improve the speed of the diagnostic process. In the sequential diagnostic fault simulator, the number of fault-pair output response comparisons has been minimized by using an indistinguis...
متن کاملA Hybrid Fault Simulator for Synchronous Sequential Circuits
Fault simulation for synchronous sequential circuits is a very time-consuming task. The complexity of the task increases if there is no information available about the initial state of the circuit. In this case, an unknown initial state is assumed which is usually handled by introducing a three-valued logic. It is known that fault simulation based upon this logic only determines a lower bound f...
متن کاملFast Fault Emulation for Synchronous Sequential Circuits
Current paper presents an approach to emulate fault simulation of sequential circuits on FPGA. Fault simulation is an important subtask in test pattern generation and it is frequently used throughout the test generation process. In the paper, we explain the problems associated to fault emulation for sequential circuits. Two alternative approaches are described, which can be considered as trade-...
متن کاملNew Fault Simulator for Large Synchronous Sequential Circuits
A fault simulator for large synchronous sequential circuits is presented in this paper. There are four key ideas to the fault simulator. 1) It uses the critical path tracing method to screen out the single event faults that need not map into equivalent stem faults. 2) It uses the single fault propagation method to map the traced single event faults into equivalent stem faults. 3) All the multip...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: VLSI Design
سال: 1996
ISSN: 1065-514X,1563-5171
DOI: 10.1155/1996/72136