Hyperband Bi-Conical Antenna Design Using 3D Printing Technique
نویسندگان
چکیده
منابع مشابه
Conical Conformal Antenna Design using the CPM Method for MIMO Systems
Abstract- In this article, the design of conformal antennas has been discussed using the characteristic modes (CM) method. For this purpose, the vector wave function(VWF) has been utilized to achieve a two-dimensional mapping of the conformal antenna. In designing and analyzing of cone-shaped antennas applicable for multi-input multi-output (MIMO) systems, the most important goal is to achieve ...
متن کاملDesign Optimization Strategy for Multifunctional 3D Printing
An optimization based design methodology for the additive manufacture of multifunctional parts (for example, a structure with embedded electronic/electrical systems and associated conductive paths) is presented. This work introduces a coupled optimization strategy where Topology Optimization (TO) is combined with an automated placement and routing approach that enables determination of an effic...
متن کاملSlotted Waveguide Antenna Design Using 3D EM Simulation
Slotted waveguide antennas (SWA) are often employed in radar applications where design specifications commonly require high gains and mechanical robustness. Since the peak power transmitted by radar antennas is usually very high, waveguide antennas present a practical alternative to planar arrays. While numerous design references and guidelines exist for planar arrays, there are far fewer for s...
متن کاملDesign of a Wideband Monopulse Antenna Using Four Conical Helix Antennas
A novel S-band monopulse antenna with four conical helix antennas on a microstrip substrate comparator is designed, fabricated and measured. Conical helix antenna height is 3λ, and comparator size is 130mm × 150mm. The bandwidth (SWR < 2 dB) of the antenna is 21.3% with an operating frequency range of 2.7GHz–3.35 GHz. The maximum gain of the sum pattern is 17.4 dB, and the null depths of the di...
متن کاملAnkle-Foot Orthosis Made by 3D Printing Technique and Automated Design Software
We described 3D printing technique and automated design software and clinical results after the application of this AFO to a patient with a foot drop. After acquiring a 3D modelling file of a patient's lower leg with peroneal neuropathy by a 3D scanner, we loaded this file on the automated orthosis software and created the "STL" file. The designed AFO was printed using a fused filament fabricat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2016
ISSN: 1757-8981,1757-899X
DOI: 10.1088/1757-899x/120/1/012010