Hydrothermal Synthesis of Japanese Acid Clay. II
نویسندگان
چکیده
منابع مشابه
Energetics of amino acid synthesis in hydrothermal ecosystems.
Thermodynamic calculations showed that the autotrophic synthesis of all 20 protein-forming amino acids was energetically favored in hot (100 degrees C), moderately reduced, submarine hydrothermal solutions relative to the synthesis in cold (18 degrees C), oxidized, surface seawater. The net synthesis reactions of 11 amino acids were exergonic in the hydrothermal solution, but all were endergoni...
متن کاملSynthesis of Single Phase Tin(II) Oxide Nanoparticles by Microwave-Assisted Hydrothermal Technique
This paper presents a novel microwave-assisted hydrothermal technique for synthesizing tin(II) oxide nanoparticles. This technique can be used for producing large quantities of homogeneous nanoparticles in a short time. The effect of the solution molarity, final pH, hydrothermal processing time and microwave power were studied. The tin(II) oxide structure verified from XRD...
متن کاملEvidence for Impact-induced Hydrothermal Clay Mineral Formation At
Introduction: Over 13 years after landing at Meridiani Planum and in her 10 extended mission, Mars Exploration Rover Opportunity continues to explore the rim of ~22 km diameter Endeavour crater [1]. The rim exposes material that is older than the S-rich, layered sedimentary rock covering the Meridiani plains and filling much of the interior of Endeavour. Clay mineral exposures at the rim have b...
متن کاملHydrothermal synthesis nanoparticle bysupercritical fluid
Supercritical fluid (SCF) technology has become an important tool of materials processing in the lasttwo decades. Supercritical CO2 and H2O are extensively being used in the preparation of a great variety ofnanomaterials. The greatest requirement in the application of nanomaterials is its size and morphology control, which determine the application potential of the nanoparticles, as...
متن کاملOrganic Synthesis using Clay Catalysts
One of the major current challenges before chemists is to develop synthetic methods that are less polluting, i.e., to design clean or ‘green’ chemical transformations. The chemical manufacturing processes should be such that they do not cause permanent damage to the environment or disturb the ecological balance. Ways to minimize the consumption of energy and raw materials used in synthesis must...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nippon kagaku zassi
سال: 1952
ISSN: 0369-5387,2185-0917
DOI: 10.1246/nikkashi1948.73.148