Hydrothermal carbonization (HTC) of loblolly pine using a continuous, reactive twin-screw extruder

Continuous Granulation with a Twin-Screw Extruder

Aqueous extraction of residual oil from sunflower press cake using a twin-screw extruder: Feasibility study

The objective of this study was to evaluate the feasibility of an aqueous process to extract the residual oil from sunflower press cakes using a co-rotating twin-screw extruder. Two different configurations were tested: the expression fromwhole seeds followed by the aqueous extraction, in two successive apparatus or in the same one. For the aqueous extraction stage, the oil yield depended on th...

Wet granulation in a twin-screw extruder: implications of screw design.

Wet granulation in twin-screw extrusion machinery is an attractive technology for the continuous processing of pharmaceuticals. The performance of this machinery is integrally tied to its screw design yet little fundamental knowledge exists in this emerging field for granulation to intelligently create, troubleshoot, and scale-up such processes. This study endeavored to systematically examine t...

Preparation of solid dispersion for ethenzamide-carbopol and theophylline-carbopol systems using a twin screw extruder.

In the present study, we prepared solid dispersions of water-insoluble and soluble drugs (ethenzamide (ETZ) and theophylline (THEO)) by the twin screw extruder method, which made it possible to control both kneading and heating at the same time under the fusion point of each drug, using three types of the controlled-release high-molecular-weight substance Carbopol (CAR) as the carrier. The soli...

evolution of co-continuous morphology along the screw length in a co-rotating twin-screw extruder and its effect on impact strength of compatibilized pa6/abs blend

an ultra-glide twin screw extruder is employed to allow the quick and easy removal of the screws from the fixed processing section within few seconds, probing the current degree of the melting state, the dispersive anddistributive processing steps and finally the level of morphology development along extruder screws. for morphological studies the molten samples, collected from different points ...