Hydrogenation of carbon monoxide on manganese oxide-supported ruthenium catalysts.
نویسندگان
چکیده
منابع مشابه
Catalytic Oxidation of Carbon Monoxide by Cobalt Oxide Catalysts Supported on Oxidized-MWCNT
Cobalt oxide catalysts supported on oxidized multi-walled carbon nanotubes (MWCNT) for the low-temperature catalytic oxidation of carbon monoxide were prepared by an impregnation-ultrasound method. These catalysts were characterized by N2 adsorption/desorption, TEM, XRD, Raman, and H2-TPR methods. The XRD and Raman results indicated that the phase of the synthesized cobalt...
متن کاملHydrogenation of carbon monoxide over vanadium oxide- promoted rhodium catalysts
The effect of vanadium oxide as support and promoter on supported rhodium catalysts on the CO hydrogenation has been investigated at 0.15 and 4.0 MPa. Rh/V,O, reduced at 723 K has a good selectivity toward oxygenated products, especially C,-oxygenates, but has a low activity added as a promoter to catalysts consisting and stability. Vanadium oxide of rhodium supported on silica and alumina show...
متن کاملCobalt promoted copper manganese oxide catalysts for ambient temperature carbon monoxide oxidation.
Low levels of cobalt doping (1 wt%) of copper manganese oxide enhances its activity for carbon monoxide oxidation under ambient conditions and the doped catalyst can display higher activity than current commercial catalysts.
متن کاملCatalytically active ceria-supported cobalt-manganese oxide nanocatalysts for oxidation of carbon monoxide.
A low-concentration cobalt (∼6 at%) and manganese (∼3 at%) bimetallic oxide catalyst supported on ceria nanorods (CoMnOx/CeO2), as well as its related single metal oxide counterparts (CoOx/CeO2 and MnOx/CeO2) was synthesized via a deposition-precipitation approach. The fresh samples after air-calcination at 400 °C were tested under the reaction conditions of CO oxidation, and showed the followi...
متن کاملCatalytic Hydrogenation of Carbon Monoxide
The hydrogenation of carbon monoxide and carbon dioxide on various steel catalysts was studied in the temperature range of 800" to 1,300'F. and at pressures from 5 to 30 atm. The feed gases (3.75 to 20 SCFH) were passed over a catalyst bed of 1/8-h. steel balls supported in a brass-lined reactor 0.81 in. in d i m . The percentage of carbon oxides in the feed was 30% in the runs using a Hz-COZ f...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of The Japan Petroleum Institute
سال: 1989
ISSN: 0582-4664
DOI: 10.1627/jpi1958.32.248