Hydrogen storage properties of Ti2FeV BCC solid solution
نویسندگان
چکیده
منابع مشابه
Magnetic properties of bcc Fe-Pd extended solid solutions
Supersaturated Fe-Pd solid solutions were prepared by mechanical alloying. X-ray diffractometry showed that the as-milled alloys were bcc from 0–26 at. % Pd. Saturation magnetization measurements and Mössbauer spectrometry measurements were performed on these powders. Consistent interpretations of both sets of measurements were possible if the magnetic moment at the Pd atom was 0.35mB and const...
متن کاملPhase Transformation and Hydrogen Storage Properties of an La7.0Mg75.5Ni17.5 Hydrogen Storage Alloy
X-ray diffraction showed that an La7.0Mg75.5Ni17.5 alloy prepared via inductive melting was composed of an La2Mg17 phase, an LaMg2Ni phase, and an Mg2Ni phase. After the first hydrogen absorption/desorption process, the phases of the alloy turned into an La–H phase, an Mg phase, and an Mg2Ni phase. The enthalpy and entropy derived from the van’t Hoff equation for hydriding were −42.30 kJ·mol−1 ...
متن کاملEFFECTS OF TiO2 ADDITIVE ON ELECTROCHEMICAL HYDROGEN STORAGE PROPERTIES OF NANOCRYSTALLINE /AMORPHOUS Mg2Ni INTERMETALLIC ALLOY
Abstract: Mg2Ni alloy and Mg2Ni–x wt% TiO2 (x = 3, 5 and 10 wt %) composites are prepared by mechanical alloying. The produced alloy and composites are characterized as the particles with nanocrystalline/amorphous structure. The effects of TiO2 on hydrogen storage properties are investigated using anodic polarization and electrochemical impedance spectroscopy. It is demonstrated that the initia...
متن کاملInternal Friction Transient Effects of Titanium Hydrogen Solid Solution
The internal friction of pure Ti between 500K and700K is constant at 10-4 when measured during a continuous increase of temperature. In opposite when the temperature is increased stepby step, each increase of 10K induces immediatly a raising up of 4 10-4 internal friction. During the following stage at the new temperature the internal friction falls slowly down to its initial value. This behavi...
متن کاملSynthesis, characterization and hydrogen storage properties of Mm(Ni,Co,Mn,Al)5 alloy
The hydrogenation characterizations of the hydrogen storage alloy MmNi4.22Co0.48Mn0.15Al0.15 (Mm= mischmetal), and the effect of hydrogenation/dehydrogenation (H/D) cycling on its structural and morphological properties are investigated. The results indicate that after several H/D cycles the alloy was pulverized into fine particles, but it kept its hexagonal CaCu5-type structure. The pressure-c...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Chemical Sciences
سال: 2019
ISSN: 0974-3626,0973-7103
DOI: 10.1007/s12039-019-1674-x