Hydrogen in pure aluminum and in aluminum alloys.
نویسندگان
چکیده
منابع مشابه
Internal Friction Peak in Cold-Worked ”Pure” Aluminum and Aluminum Alloys
Low frequency internal friction measurements have been made on "pure" aluminum and dilute aluminum alloys in heavily cold-worked states. A relaxation peak is observed at about 200 K(for 1Hz) even in specimens of nominally 4N or higher purity. This peak is considered to be the same as those previously reported by several researchers for dilute aluminum alloys of Cu, Mg or Ga. Among various eleme...
متن کاملAluminum and Aluminum Alloys Casting Problems
Aluminum castings have played an integral role in the growth of the aluminum industry since its inception in the late 19th century. The first commercial aluminum products were castings, such as cooking utensils and decorative parts, which exploited the novelty and utility of the new metal. Those early applications rapidly expanded to address the requirements of a wide range of engineering speci...
متن کاملReversible twinning in pure aluminum.
Twinning in metals is normally a permanent plastic deformation mechanism. Here we report reversible twinning in high stacking fault energy (SFE) aluminum. Twinning and spontaneous detwinning at the crack tip have been captured in situ during tensile straining under a transmission electron microscope. Both the in situ observation and the molecular dynamics simulations reveal a two-stage detwinni...
متن کاملEffects on Structural Aluminum Alloys
HEDRICK, H. G. (General Dynamics/Fort Worth, Fort Worth, Tex.), C. E. MILLER, J. E. HALKIAS, AND J. F. HILDEBRAND. Selection of a microbiological corrosion system for studying effects on structural aluminum alloys. Appl. Microbiol. 12:197200. 1964.Two laboratory methods, a metal-strip test and a tank test, were evaluated as microbiological corrosion systems for producing corroded test specimens...
متن کاملMicrowave Sintering of Aluminum Alloys
Until 2000 almost all research in the microwave sintering area was confined to non-metallic materials. However, after the first report by Penn State in 1999 on full sintering of steel powders in microwave, now in the last few years there has been increasing interest in applying microwave energy for processing of variety of metallic materials. The present study is an extension of this work and r...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1989
ISSN: 0451-5994
DOI: 10.2464/jilm.39.235