Hydrogen absorption study of ti-based alloys performed by melt-spinning
نویسندگان
چکیده
منابع مشابه
Hydrogen Storage Properties and Structure of Magnesium-Based Alloys Prepared with Melt-Spinning Technique
© 2012 Tanaka, licensee InTech. This is an open access chapter distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/3.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. Hydrogen Storage Properties and Structure of Magnesium-Based Alloys Prepared with Melt-Spinn...
متن کاملHydrogen Isotope Effects on Absorption Properties of Ti–Cr–V Alloys*
Ti–Cr–V alloys are known to absorb protium (hydrogen atom) up to H/M = 2, while Cr-rich alloys absorb up to H/M = 1 because of the formation of mono-protides (mono-hydrides). However, few hydrogen isotope effects of the Ti–Cr–V alloys have been reported. This paper aims to clarify the hydrogen isotope effects on the absorption properties of the Ti–Cr–V alloys in a composition range near the bou...
متن کاملThermal Stability of P-Type BiSbTe Alloys Prepared by Melt Spinning and Rapid Sintering
P-type BiSbTe alloys have been widely implemented in waste heat recovery from low-grade heat sources below 600 K, which may involve assorted environments and conditions, such as long-term service, high-temperature exposure (generally 473-573 K) and mechanical forces. It is important to evaluate the service performance of these materials in order to prevent possible failures in advance and exten...
متن کاملHydrogen Absorption/Desorption Properties in the TiCrV Based Alloys
Three different Ti-based alloys with bcc structure and Laves phase were studied. The TiCr 1.1 V 0.9 , TiCr 1.1 V 0.45 Nb 0.45 and TiCr 1.1 V 0.9 + 4%Zr 7 Ni 10 alloys were melted in arc furnace under argon atmosphere. The hydrogen absorption capacity was measured by using aparatus type Sievert’s. Crystal structures, and the lattice parameters were determined by using X-ray diffraction, XRD. Mic...
متن کاملMelt Protection of Mg-Al Based Alloys
This paper reports the current status of Mg melt protection in view to identify near-future challenges, but also opportunities, for Mg melt protection of Mg-Al based alloys. The goal is to design and manufacture sustainable Mg alloys for resource efficiency, recycling and minimising waste. Among alternative cover gas technologies for Mg melt protection other than SF6: commercially available tec...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Research
سال: 2013
ISSN: 1980-5373,1516-1439
DOI: 10.1590/s1516-14392013005000049