Hydraulic Performance of an S-Draft Tube for a Low-Head Axial Flow Turbine (How to Improve the Performance and Unsteady Secondary Flow in a S-Draft Tube)
نویسندگان
چکیده
منابع مشابه
Numerical Study of a Pipe Extension Effect in Draft Tube on Hydraulic Turbine Performance
Draft tube of Francis type hydraulic turbine usually consists of: cone, elbow and diffuser. On the contrary, in some power stations an extra pipe should be added to the draft tube at the bottom of cone because of installation limitation. In this paper, this special case has been numerically studied. To this end CFD analysis was applied to simulate all parts of hydraulic turbine. A homogeneous m...
متن کاملCorrelation Dimension for Pressure Fluctuation in Hydraulic Turbine Draft Tube
Based on the actual experiment signals of draft tube, the correlation dimension analysis has been carried on using the time domain signals. Through correlation dimension analysis of pressure fluctuating under different load, the results indicate that the pressure fluctuation conditions in draft tube are not same under different load, the corresponding fractal correlation dimensions are also dif...
متن کاملHydraulic Network Modeling to Analyze Stream Flow Effectiveness on Heat Transfer Performance of Shell and Tube Heat Exchangers
In this article, stream flow effectivness is based on hydraulic network studied in the shell-side of a shell and tube heat exchange as a case study. For an appropriate heat exchangers rating design to meet a specified duty, it's better to consider each stream flow separately. Using the hydraulic network principals, a set of the correlations for calculating different stream flow rates in the cro...
متن کاملPredictive modeling of biomass production by Chlorella vulgaris in a draft-tube airlift photobioreactor
The objective of this study was to investigate the growth rate of Chlorella vulgaris for CO2 biofixation and biomass production. Six mathematical growth models (Logistic, Gompertz, modified Gompertz, Baranyi, Morgan and Richards) were used to evaluate the biomass productivity in continuous processes and to predict the following parameters of cell growth: lag phase duration (λ), maximum specific...
متن کاملFlow Visualization Around a Non - Circular Tube
The flow behavior around a cam shaped tube in cross flow has been investigated experimentally using flow visualization and pressure distribution measurement. The range of attack angle and Reynolds number based on an equivalent circular diameter are within 0 ≤ α ≤ 360˚ and 2 x 104 < Reeq < 3.4 x 104, respectively. The pressure drag features are clarified in relation to the flow behavior around t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JSME international journal. Ser. 2, Fluids engineering, heat transfer, power, combustion, thermophysical properties
سال: 1988
ISSN: 0914-8817
DOI: 10.1299/jsmeb1988.31.4_668