Hybrid Massive MIMO for Urban V2I: Sub-6 GHz vs mmWave Performance Assessment
نویسندگان
چکیده
منابع مشابه
Massive MIMO in Sub-6 GHz and mmWave: Physical, Practical, and Use-Case Differences
The use of base stations (BSs) and access points (APs) with a large number of antennas, called Massive MIMO (multiple-input multiple-output), is a key technology for increasing the capacity of 5G networks and beyond. While originally conceived for conventional sub-6GHz frequencies, Massive MIMO (mMIMO) is ideal also for frequency bands in the range 30-300GHz, known as millimeter wave (mmWave). ...
متن کاملPartially Blind Handovers for mmWave New Radio Aided by Sub-6 GHz LTE Signaling
We propose to estimate mmWave received signal power levels using supervised machine learning and LTE signal measurements in sub-6 GHz bands. Contributions of this paper include 1) introduction of partially blind handovers, 2) demonstration that LTE measurements from sub-6 GHz LTE bands can help improve handover to mmWave frequency bands, and 3) an algorithm to improve handover success rates usi...
متن کاملAntenna Count for Massive MIMO: 1.9 GHz versus 60 GHz
If we assume line-of-sight propagation and perfect channel state information at the base station – consistent with slow moving terminals – then a direct performance comparison between single-cell Massive MIMO at PCS and mmWave frequency bands is straightforward and highly illuminating. Line-of-sight propagation is considered favorable for mmWave because of minimal attenuation, and its facilitat...
متن کاملmmWave Massive MIMO with Simple RF and Appropriate DSP
There is considerable interest in the combined use of millimeter-wave (mmwave) frequencies and arrays of massive numbers of antennas (massive MIMO) for next-generation wireless communications systems. A symbiotic relationship exists between these two factors: mmwave frequencies allow for densely packed antenna arrays, and hence massive MIMO can be achieved with a small form factor; low per-ante...
متن کاملEnergy Efficiency and Asymptotic Performance Evaluation of Beamforming Structures in Doubly Massive MIMO mmWave Systems
Future cellular systems based on the use of millimeter waves will heavily rely on the use of antenna arrays both at the transmitter and at the receiver. For complexity reasons and energy consumption issues, fully digital precoding and postcoding structures may turn out to be unfeasible, and thus suboptimal structures, making use of simplified hardware and a limited number of RF chains, have bee...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Vehicular Technology
سال: 2020
ISSN: 0018-9545,1939-9359
DOI: 10.1109/tvt.2020.2982743