HYBRID LAYER THICKNESS IN PRIMARY AND PERMANENT TEETH – A COMPARISON BETWEEN TOTAL ETCH ADHESIVES
نویسندگان
چکیده
منابع مشابه
بررسی مقایسه‌ای میزان نشت نانومتری در ترمیمهای کامپوزیت متعاقب کاربرد مواد چسبنده عاجی سلف اچ و توتال اچ در دندانهای شیری و دائمی1
Background and Aim: Nanoleakage can cause discoloration around restoration margins, secondary caries, postoperative sensitivity and finally loss of restoration, thus adequate hybrid layer is of primary importance in prevention of nanoleakage in adhesive restorations. Because of structural differences between primary and permanent dentin, evaluation of nanoleakge in primary teeth is very importa...
متن کاملComparison of Microleakage of Self-etch and Total-etch Bonding Agents in Primary Molar Class II Composite Restorations
Introduction: This study evaluated microleakage of flowable and conventional composite in primary molar class II restorations using self-etch and total-etch bonding agents. Methods: Class II standard cavities were prepared on proximal surface of 48 primary molars. These cavities were restored using GrandioFlow and Grandio composites and Futurabond DC and Solobo...
متن کاملcomparison of zoe and vitapex for canal treatment of necrotic primary teeth
چکیده ندارد.
15 صفحه اولComparison of dentine-resin interface in total-etch and self-etching adhesives using electron microscopy.
The important condition for the adhesive bond between dentine and composite filling is the change of dentine property from hydrophilic to hydrophobic. Substances able to accomplish this change, dentinal adhesives, have undergone complex development. Recently, the so-called self-etching adhesives have been formulated. The aim of the present paper was to compare the structural pattern of dentin/r...
متن کاملDegradation of resin-dentin bonds of etch-and-rinse adhesive system to primary and permanent teeth.
The aim of this in vitro study was to compare the degradation of resin-dentin bonds of an etch-and-rinse adhesive system to primary and permanent teeth. Flat superficial coronal dentin surfaces from 5 primary second molars and 5 permanent third molars were etched with phosphoric acid and bonded with an adhesive system (Adper Single Bond 2, 3M ESPE). Blocks of resin composite (Z250, 3M ESPE) wer...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of IMAB - Annual Proceeding (Scientific Papers)
سال: 2012
ISSN: 1312-773X
DOI: 10.5272/jimab.2012182.191