Hot Pressing of Titanium Carbide-Nickel Cermet and Alumina
نویسندگان
چکیده
منابع مشابه
Argon-shielded hot pressing of titanium alloy (Ti6Al4V) powders.
The paper presents the method of the argon - shielded hot pressing of titanium alloy (Ti6A14V) powder (used in medical industry). The powders produced in the GA (gas atomization) process and in the HDH (hydride - dehydride) process were used in the experiments. A pressing process was conducted at a temperature of 800-850 degrees C for different lengths of time. An unoxidized sintered material, ...
متن کاملComparison of Creep Behavior in Alumina Based Ceramics Densified by Spark Plasma Sintering and Hot Pressing
Spark plasma sintering (SPS) method, as plasma activated sintering, is a method applicable for rapid sintering of metals and ceramics. Owing to the advantage of rapid heating, the alumina ceramics obtained by SPS have a grain size and density comparable to those of hot pressed ones. The increase of densification rate may be related to some difference in ion transport characteristics. This study...
متن کاملAmmrc Tr 68-17 Titanium Carbide Content Effect on Erosion in Cermet Rocket Nozzles
Analyses were carried out on subscale cermet nozzles fired in the AMMRC solid propellant engine at a designated maximum chamber pressure of 1100 psi for nominal burning times of 15 jeconds in order to determine mechanisms of erosion and the effect of the carbide constituent on erosion. The cermet class investigated consisted of an AISI Type 316 stainless steel matrix incorporating a hard phase ...
متن کاملThermoelectric Properties of Alumina-Doped Bi0.4Sb1.6Te3 Nanocomposites Prepared through Mechanical Alloying and Vacuum Hot Pressing
In this study, γ-Al2O3 particles were dispersed in p-type Bi0.4Sb1.6Te3 through mechanical alloying to form γ-Al2O3/Bi0.4Sb1.6Te3 composite powders. The composite powders were consolidated using vacuum hot pressing to produce nanoand microstructured composites. Thermoelectric (TE) measurements indicated that adding an optimal amount of γ-Al2O3 nanoparticles improves the TE performance of the fa...
متن کاملThe vacuum hot pressing behavior of silicon carbide fibers coated with nanocrystalline Ti–6Al–4V
The vacuum hot pressing (VHP) of silicon carbide monofilaments coated with nanocrystalline Ti–6Al–4V has been studied. During consolidation, very high densification rates were observed, even at temperatures and pressures well below those normally used for processing conventional Ti–6Al–4V. From the cross-sections of partially consolidated specimens, the evolution of coated fiber–fiber contacts ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of the Society of Chemical Industry, Japan
سال: 1960
ISSN: 0023-2734,2185-0860
DOI: 10.1246/nikkashi1898.63.7_1121