Hot Pressing of Boron Carbide Based Ceramic Composites
نویسندگان
چکیده
منابع مشابه
High-strength zirconium diboride-based ceramic composites consolidated by low-temperature hot pressing.
Two compositions of ZrB2-based ceramic composites containing Si3N4, Al2O3 and Y2O3 have been hot-pressed at different temperatures between 1673 and 1773 K for 60 min in vacuum. The densification behavior of the composites was examined during the sintering process. The microstructures of the composites were characterized by scanning electron microscopy, and the crystalline phases were identified...
متن کاملStrength and Toughness of Ceramic-metal Prepared by Reactive Hot Pressing Composites
William G. Fahrenholtz o 9m Ceramic Engineering Department ‘so University of Missouri-Rolls w~!!l Rolls, MO 65409 + <. +# Metal-reinforced Alz03-matrix composites were prepared using reactive hot pressing. The volume fraction of the reinforcing phase was controlled by the stoichiometry of the particular displacement reaction used. Dense Alz03-Ni and Al@3-N’b composites were fabricated using thi...
متن کاملInvestigation of the Physical and Mechanical Properties of Hot-Pressed Boron Nitride/Oxide Ceramic Composites
Billets of hexagonal boron nitride powders (h-BN) were hot-pressed, varying the alignment of the platelike particles and the amount of oxide additives. Increasing either alignment of individual grains or the amount of additives was shown to increase flexural strength, to approximately 120 MPa at ambient temperatures. h-BN was shown to deflect cracks initially propagating normal to its basal pla...
متن کاملCharacterization Of Particulate-Reinforced Aluminium 6061 / Boron Carbide Composites
Aluminum-based metal matrix composite (MMC) materials are used in the design of ground transportation vehicles and aircraft. Compared with conventional, unreinforced alloys, composite materials usually exhibit higher strength, both at ambient and elevated temperatures, as well as good fatigue strength and wear resistance. MMCs could be produced by variety of methods such as Stir cast, Liquid In...
متن کاملSynthesis and Sintering of Ti3SiC2–SiC Composites through Reactive Hot-Pressing of TiC and Si Precursors
MAX phases are an attractive class of layered solids that have recently attracted a great deal of attention due to their unusual and unique composition. The ternary compound Ti3SiC2 is an example of a material that combines the properties of ceramics and metals. As a ceramic, they are high stiff. Some of them are resistant to oxidation, creep, fatigue, corrosion. They are extremely refractory a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Manufacturing Technology
سال: 2020
ISSN: 1213-2489,1213-2489
DOI: 10.21062/mft.2020.046