Hot Gas Forming of Aluminum Alloy Tubes Using Flame Heating
نویسندگان
چکیده
منابع مشابه
Flexible Forming of Thin Aluminum Alloy Sheets
Flexible forming is a sheet metal forming process with the application of soft material tooling. In this study, flexible (silicone rubber, SR, and styrene butadiene rubber, SBR) and semi-rigid (polyamide 66, PA) polymeric materials were adopted to make several upper dies which were used in combination with aluminium lower dies. Stamping operations were performed on a thin aluminium alloy sheet ...
متن کاملInvestigation of hot metal gas forming process of square parts
Aluminum alloys are considered a lot in the automotive and aerospace industry because of their high strength to weight ratio. In this manuscript, the gas forming process of aluminum AA6063 tubes at high temperatures up to 500°C is investigated, through experimental and numerical tests. Therefore, an experimental setup is prepared and so, tube specimens are formed in a die with square cross sect...
متن کاملDual–Phase Hot–Press Forming Alloy
Hot–press forming steels are formed in a fully austenitic state followed by die– quenching in order to generate martensite and achieve a strong steel. The ductility however, tends to be limited. We explore in this work a novel steel design in which the forming operation is in the two–phase austenite and ferrite field, so that the quenching results in a dual–phase ferrite and martensite microstr...
متن کاملThe Effects of Forming Parameters on the Single Point Incremental Forming of 1050 Aluminum Alloy Sheet
The single point incremental forming (SPIF) is one of the dieless forming processes which is widely used in the sheet metal forming. The correct selection of the SPIF parameters influences the formability and quality of the product. In the present study, the Gurson-Tvergaard Needleman (GTN) damage model was used for the fracture prediction in the numerical simulation of the SPIF process of alum...
متن کاملFabrication of Aluminum Tubes Filled with Aluminum Alloy Foam by Friction Welding
Aluminum foam is usually used as the core of composite materials by combining it with dense materials, such as in Al foam core sandwich panels and Al-foam-filled tubes, owing to its low tensile and bending strengths. In this study, all-Al foam-filled tubes consisting of ADC12 Al-Si-Cu die-cast aluminum alloy foam and a dense A1050 commercially pure Al tube with metal bonding were fabricated by ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Manufacturing and Materials Processing
سال: 2020
ISSN: 2504-4494
DOI: 10.3390/jmmp4020056