Hot-dip Zinc-Aluminum Alloy Coated Steel Sheet
نویسندگان
چکیده
منابع مشابه
Microstructural evolution during recrystallization in hot rolled Aluminum Alloy 1050
The evolution of texture as a function of recrystallization has been characterized for hot-rolled AA1050. Samples prepared from a hot rolled sheet were annealed isothermally for sufficient time to allow complete recrystallization. The spatial orientation variation within the deformed microstructure of nucleation, growth and orientations of recrystallized grains is examined. The microstructural ...
متن کاملEffect of heat treatment on microstructural properties of three-layer sheet aluminum magnesium - aluminum - stainless steel
Metal coating, metal materials are of two or more layers. The coating metals are widely used in industry. These sheets or saving performance and cost effective solution or both the user. Performance coating metals according to usage in structural applications, settings thermal expansion of the thermo-mechanical control (thermostat), electrical, magnetic, corrosion resistant, flowering and decor...
متن کاملKeyhole behaviour during laser welding of zinc-coated steel
The production of consistent, high-quality laser welds on zinc-coated steels for the automotive industry remains a challenge. A simple overlap joint geometry is desirable in these applications but has been shown to be extremely detrimental to laser welding because the zinc vapour formed at the interface between the two sheets expands into the keyhole and disrupts fluid flow in the melt pool, wh...
متن کاملDrying dip-coated colloidal films.
We present the results from a small-angle X-ray scattering (SAXS) study of lateral drying in thin films. The films, initially 10 μm thick, are cast by dip-coating a mica sheet in an aqueous silica dispersion (particle radius 8 nm, volume fraction ϕ(s) = 0.14). During evaporation, a drying front sweeps across the film. An X-ray beam is focused on a selected spot of the film, and SAXS patterns ar...
متن کاملInfluence of Shielding Gas on Fume and Gas Emission during Arc Weld Brazing of Steel Sheets with Coatings
J. Matusiak, J. Wyciślik, Institute of Welding, Gliwice, Poland The article presents the results of research into the fume and gas emission during MIG/MAG arc weld brazing. Investigations were conducted for hot dip coated steel sheets with zinc and zinc and iron alloy coatings. Steel grades of DX 54D Z 100 MBO and DX 54D ZF 100 RBO were used during research. ARC shielding gases applied were Ar ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of The Surface Finishing Society of Japan
سال: 2010
ISSN: 0915-1869,1884-3409
DOI: 10.4139/sfj.62.8