منابع مشابه
Hot deformation studies on discontinuously reinforced Ti-Alloys
Titanium alloys exhibit high specific strength and stiffness that fit structural applications demanding lightweight. The microstructure of the alpha-beta titanium alloys can be changed by thermomechanical processes such as heat treatments and pre-forging to achieve a certain ductility. Ceramic reinforcements can improve specific strength and stiffness, and also the wear resistance. In Situ part...
متن کاملHot Deformation Behavior and Pulse Current Auxiliary Isothermal Forging of Hot Pressing Sintering TiAl Based Alloys
This paper focuses on the fabrication of as-forged Ti46.5Al2Cr1.8Nb-(W, B) alloy via pulse current auxiliary isothermal forging (PCIF). The starting material composed of near gamma (NG) microstructure was fabricated by adopting pre-alloyed powders via hot pressing sintering (HPS) at 1300 °C. Isothermal compression tests were conducted at a strain rate range of 0.001-0.1 s-1 and a temperature ra...
متن کاملAluminum and Aluminum Alloys Casting Problems
Aluminum castings have played an integral role in the growth of the aluminum industry since its inception in the late 19th century. The first commercial aluminum products were castings, such as cooking utensils and decorative parts, which exploited the novelty and utility of the new metal. Those early applications rapidly expanded to address the requirements of a wide range of engineering speci...
متن کاملMicrowave Sintering of Aluminum Alloys
Until 2000 almost all research in the microwave sintering area was confined to non-metallic materials. However, after the first report by Penn State in 1999 on full sintering of steel powders in microwave, now in the last few years there has been increasing interest in applying microwave energy for processing of variety of metallic materials. The present study is an extension of this work and r...
متن کاملTwo-Phase Modeling of Hot Tearing in Aluminum Alloys: Applications of a Semicoupled Method
Hot tearing formation in both a classical tensile test and during direct chill (DC) casting of aluminum alloys has been modeled using a semicoupled, two-phase approach. Following a thermal calculation, the deformation of the mushy solid is computed using a compressive rheological model that neglects the pressure of the intergranular liquid. The nonzero expansion/ compression of the solid and th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1990
ISSN: 0451-5994
DOI: 10.2464/jilm.40.951