Hollow-Cone Like Spray Formation by Using Plate Type Multi-Hole Nozzle
نویسندگان
چکیده
منابع مشابه
Numerical characterization of multi-nozzle spray cooling
This work aims to study the characteristics of multi-nozzle spray cooling using CFD method based on the fundamentals of air flow and liquid droplet collision dynamics. A mathematical model for the two-phase flow was presented. The simulations were performed using a EulerianeLagrangian approach. Focus was placed on revealing the flow behavior with multiple nozzles, the droplet trajectory, and th...
متن کاملPlanar droplets sizing of a hollow-cone spray using SLIPI-LIF/MIE
In this work, we report an original experimental approach for measuring the two-dimensional distribution of the droplets Sauter Mean Diameter (SMD) using the SLIPI-LIF/MIE technique. A hollow-cone spray is formed by continuously injecting water mixed with a non-toxic fluorescing dye at 20 bars injection pressure. The spray is illuminated using a continuous wave laser. The illumination wavelengt...
متن کاملSimulation and Control of Spray Drying Using Nozzle Atomizer Spray Dryer
Spray drying is a commonly used method of drying a liquid feed through a hot gas. This study aims to obtain the empirical model of the spray drying process of full cream milk using a nozzle atomizer spray dryer, Lab-Plant SD 05 Laboratory Scale Spray Dryer. Inlet air temperature was chosen as the manipulated variable and outlet air temperature was the controlled variable. No disturbance was con...
متن کاملInfluence of nozzle type, nozzle arrangement and side wind speed on spray drift as measured in a wind tunnel
Spray drift is a great concern because of environmental consequences of agricultural practices. Many studies were conducted in wind tunnel (Miller, 2011; Nuyttens, 2007; Herbst, 2003) mainly focusing on the definition of quantitative deposition on collectors at different distances or heights according to (ISO 22856, 2008). In most cases, only one nozzle positioned frontally (wind direction perp...
متن کاملExperimental Analysis of the effect of very early pilot injection on pollutant formation for a PCCI Diesel engine
In the present work, the influence of a very early pilot injection on pollutant formation was investigated in a Common-Rail DI Diesel engine. The engine was operated at conventional part-load conditions at 2000 rpm, an EGR variation was done and the injected fuel mass was 15 mm^3/cycle. The Nozzle type were conical and flow optimized geometries (ks nozzle) with hole diameters of 0.141 mm, lengt...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 2004
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.70.2160