Highly linear balanced power amplifiers for carrier aggregation
نویسندگان
چکیده
منابع مشابه
Designing Highly-linear Microwave Power Amplifiers Based
This paper shows how intermodulation distortion, IMD, sweet spots can be used as a practically meaningful technology to design highly linear microwave power amplifiers. It starts by reviewing the physical origins of these points of large signal to nonlinear distortion ratio, distinguishing the ones uniquely determined by the active device’s quiescent point – small-signal IMD sweet spots – from ...
متن کاملGaN Device for Highly Efficient Power Amplifiers
Fujitsu has been developing gallium nitride high electron mobility transistors (GaNHEMT) for small transmitter amplifiers for Long Term Evolution (LTE) base stations. The use of GaN-HEMT in highly efficient transmitter amplifiers has attracted much attention because of its high breakdown voltage characteristics. High-efficiency amplifiers with high gain are needed to decrease the power consumpt...
متن کاملHigh Power and Highly Linear Monolithically Integrated Distributed Balanced Photodetectors
A distributed balanced photodetector with high saturation photocurrent and excellent linearity has been experimentally demonstrated. The maximum linear direct current (dc) photocurrent of 33 mA per branch is equivalent to 66mA in single-ended photodetectors. A setup for investigating the alternating current (ac) linearity of the receiver is proposed and experimentally demonstrated. The receiver...
متن کاملNon-linear models for High Power Amplifiers
In this chapter we start by developing the analytical formulation of a general structure for the nonlinear distortion. This formulation, based on the Volterra series expansion, is provided in order to demonstrate the validity of some classical approximations concerning the use of higher order nonlinear models for HPA characterization. Then, one of the most validated HPA models is described in s...
متن کاملInverse Modeling Estimation Algorithm for Multi-Carrier High Power Amplifiers
Many predistortion schemes use a memoryless approach [1, 2], but with broadband systems, where the bandwidth is typically larger than five MHz, the PA typically can no longer be considered a memory-less system. With this, the inverse transfer function of the PA—which describes the forward transfer function of the required pre-distorter function—can no longer be obtained using memory-less approa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Microwave and Optical Technology Letters
سال: 2018
ISSN: 0895-2477
DOI: 10.1002/mop.31014