Highly conductive wear resistant Cu/Ti3SiC2(TiC/SiC) co-continuous composites via vacuum infiltration process
نویسندگان
چکیده
منابع مشابه
Bioinspired highly electrically conductive graphene–epoxy layered composites
Key Laboratory of Bio-inspired Smart Interfa Education, School of Chemistry and Enviro China. E-mail: [email protected]; Fax: +8 Science and Technology on Advanced Com Aeronautical Materials, AVIC Composites T China Key Laboratory for Biomechanics and Me School of Biological Science and Medical E P. R. China † Electronic supplementary information comments relevant to but not central to experime...
متن کاملElectrically Conductive Latex-Based Composites
Electrically conductive polymer composites filled with carbon black can exhibit the mechanical behavior of a polymer and metallic electrical conductivity. Unfortunately, excessive amounts of carbon black can produce brittle films and too little carbon black can result in low conductivity. Composite conductivity can be dramatically improved by using latex as the matrix starting material. Latex p...
متن کاملMechanical and Wear Properties of Al-Nip Composites Produced by ARB Process
In this research, Al-Ni particle composite strips are formed by accumulative roll bonding (ARB) process using Al strips and Ni powder. The rule of ARB cycles and volume percentage (Vol%) of Ni powder on the microstructure, wear resistance and mechanical properties of the formed composites are investigated. According to the tensile test results, the yield stress and tensile strengths of the Al -...
متن کاملWear of Aged Dental Composites
Surface morphology and wear characteristics of five dental composites subjected to accelerated aging were investigated. Aging conditions caused degradation of the surface as evidenced by the formation of microcracks and the exposure and loss of filler particles. Wear parameters such as track width, transition load and mode of surface failure caused by single-pass sliding were influenced by agin...
متن کاملThree-body wear of different composites resins
Introduction: Low resistance of composite resins to abrasion is a primary concern in the application of these materials for posterior restorations which are prone to high occlusal loads. This study compared the wear resistance of three types of composites. Methods: In this laboratory experiment, five specimens of each of the three types of composites (z250, Heliomolar, Opallis) were prepared...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Advanced Ceramics
سال: 2020
ISSN: 2226-4108,2227-8508
DOI: 10.1007/s40145-019-0350-4