High velocity impact response of Kevlar-29/epoxy and 6061-T6 aluminum laminated panels

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Aluminum-laminated Panels: Physical and Mechanical Properties

Aluminum lamination was performed to improve the physical and mechanical properties of several wood-based composite panels. The panels were aluminum-laminated on two faces in a hot press at 689 kPa and 120 °C for 6 min. Four types of wood-based composites were used as cores, and aluminum 3003 alloy sheets were used for face laminations. Polyurethane adhesive ensured bonding strength between the...

متن کامل

Two-dimensional Mapping of Residual Strains in 6061-t6 Aluminum Alloy Friction Stir Welds

The residual strain profiles were measured through the thickness of friction-stir welded (FSW) plates using neutron diffraction to study the relationship between the angular distortion and the residual strain distribution. Three different weld specimens were prepared from a 6061-T6 aluminum alloy with the purpose of separating the effects of the frictional heat and plastic deformation on the re...

متن کامل

Sensitivity analysis of low-velocity impact response of laminated plates

We analyze the sensitivity to values of material parameters, layer thickness and impact speed of the plate deflection, the contact force between the impactor and the plate, the maximum length of a crack, and the energy dissipated during the low velocity impact at normal incidence of a clamped rectangular laminate by a rigid hemispherical-nosed cylinder. The laminate is comprised of layers of po...

متن کامل

High-velocity impact properties of multi-walled carbon nanotubes/E-glass fiber/epoxy anisogrid composite panels

This work reports the high-velocity impact response of multiscale anisogrid composite (AGC) panels. The aim of the present study is to evaluate the influence of surface-modified multi-walled carbon nanotubes (S-MWCNTs) at different S-MWCNTs contents (0-0.5 wt.% at an interval of 0.1 wt.%) on the high-velocity impact responses of E-glass/epoxy AGC. Surface modification of MWCNTs is confirmed by ...

متن کامل

Microstructure and Mechanical Properties of Dissimilar Friction Stir Welding between Ultrafine Grained 1050 and 6061-T6 Aluminum Alloys

The ultrafine grained (UFGed) 1050 Al plates with a thickness of 2 mm, which were produced by the accumulative roll bonding technique after five cycles, were friction stir butt welded to 2 mm thick 6061-T6 Al alloy plates at a different revolutionary pitch that varied from 0.5 to 1.25 mm/rev. In the stir zone, the initial nano-sized lamellar structure of the UFGed 1050 Al alloy plate transforme...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Materials & Design

سال: 2013

ISSN: 0261-3069

DOI: 10.1016/j.matdes.2012.06.034