High value activated carbons from waste polystyrene foams
نویسندگان
چکیده
منابع مشابه
Surface Area Determination of Activated Carbons Produced from Waste Tires Using Adsorption from Solution
The following study demonstrates the possibility of producing different activated carbons from a mixture of waste tires and tubes. The mixture was pyrolyzed at different temperatures namely (400,450 and 500 о C) for two hours for the determination of best condition of heating. It was found through the study that semi carbonized marital produced via pyrolyis at 500 о C was the best; thus it was ...
متن کاملAdsorption of acid dye onto activated carbons prepared from agricultural waste bagasse by ZnCl2 activation.
A series of activated carbons were prepared from agricultural waste sugarcane bagasse by chemical activation with zinc chloride (ZnCl2) as an activating agent at 500 degrees C and 0.5 h soaking time. The Langmuir surface area and total pore volume were used to estimate the average pore diameter of the carbon products. The values of the surface area and pore volume increased linearly with increa...
متن کاملActivated carbons from oil-fired fly ashes
Introduction. The aim of this investigation is to prepare activated carbons with good sorbent characteristics from oil-fired fly ash, looking for suitable activation processes to produce surface sites with high reactivity on the carbonaceous matrices [1-4]. In particular, the nitrogen surface sites, formed by gaseous ammonia reaction at 800°C, could greatly increase the adsorption of gaseous sp...
متن کاملPyrolysis of Waste Polystyrene and High-Density Polyethylene
As the rate of consumption of plastic materials in the world is greatly expanded, more waste plastics are generated. In recent years, their generation amount in Korea becomes about four million tons per year, according to data from the National Institute of Environmental Research. The disposal of waste plastic is mostly achieved by conventional ways such as landfill or incineration. However, th...
متن کاملCO, Adsorption Techniques On High Surface Area Activated Carbons
For years the subject of CO, adsorption on activated carbons has been both challenged and supported. The question remains whether or not CO, is a valid adsorbate for characterizing pore structures of activated carbons. The predominance of nitrogen adsorption as a routine experimental technique for BET surface area approximations has more or less overshadowed the limitations of this technique in...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Microporous and Mesoporous Materials
سال: 2018
ISSN: 1387-1811
DOI: 10.1016/j.micromeso.2018.03.027