High Temperature Sulfidation and Oxidation Behavior of Sputter-Deposited Al-refractory Metal Alloys
نویسندگان
چکیده
منابع مشابه
High Temperature Erosion- Oxidation Behavior of Nickel- Based Alloys Containing Mo in Fluidized Bed Waste Incineration
High-temperature erosion-oxidation behavior of nickel-based alloys containing 0-7 wt.% Mo in fluidized bed waste incineration conditions was studied. A stream of hot condensed air with a flow rate of 25 L/min caused hot silica sand (700 °C) mixed with 0.5 wt.% of chloride salts to hit the specimens for 250 h. By removing the erosive factor, the high-temperature oxidation behavior of the alloys ...
متن کاملApproaches to oxidation-resistant refractory metal alloys
The focus of the research reported here was on the design of high-temperature alloys which would form protective Si02 and A1203 scales on exposure to high-temperature, oxidizing environments. One way to promote the growth of such scales is to incorporate sufficient amounts of Si or A1 in the alloy substrate; typically, additions of approximately 35 to 45 weight percent (all alloy compositions a...
متن کاملTribological behavior of sputter-deposited MoSX/Ni coatings
AbstractSputtered MoS2 coatings have been mostly used as a solid lubricant. In this investigation, MoSx/Ni composite coatings with Ni contents varying from 0 to 22 % were deposited onto steel substrate using a DC magnetron sputter process. The MoS2/Ni ratio in the coatings was controlled by sputtering the composite targets. The composition, microstructure, and mechanical properties of the...
متن کاملOxidation and Sulfidation-oxidation of Fe-based Alloys in H2-h2s-co2 Gas
Introduction: A primary goal of meteoritics is to determine the physical and chemical environments in the early solar system that led to the properties of planets and other solid bodies. Since metal is highly reac-tive in oxidizing and sulfidizing atmospheres, it and its corrosion scales can record the composition and conditions of any alteration fluid that interacted with it. Metal-troilite-ox...
متن کاملHIGH TEMPERATURE ELASTIC PROPERTIES OF REFRACTORY MATERIALS
Abstract: A pulse-echo technique, based on ultrasonic "long-bar" mode (LBM) velocity measurements, working up to 1700°C is described. Magnetostrictive transducers and ultrasonic lines used in a 40-85 kHz frequency range are detailed. The conditions of choice of fundamental parameters (frequency, line geometry, sample size) are discussed in relation with the nature and the microstructure of ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Transactions, JIM
سال: 1996
ISSN: 0916-1821,2432-471X
DOI: 10.2320/matertrans1989.37.379