منابع مشابه
High-Strength Bainitic Steels
With careful design, mixed microstructures consisting of fine plates of upper bainitic ferrite separated by thin films of stable retained austenite have exhibited impressive combinations of strength and toughness in highsilicon bainitic steels. The silicon suppresses the precipitation of brittle cementite leading to an improvement in toughness. The essential principles governing the optimisatio...
متن کاملExperimental investigation of the strength of glass fiber-reinforced concrete exposed to high temperature
This study investigated the effects of high temperature exposure on the compressive, tensile, and flexural strengths of concrete containing glass fiber. A total of 108 cubic specimens (150 mm × 150 mm × 150 mm), cylindrical specimens (300 mm × 150 mm), and prismatic specimens (500 mm × 150 mm × 150 mm) were prepared for compressive, tensile, and flexural strength testing, respectively. The spec...
متن کاملYield Strength of a-Silicon Nitride at High Pressure and High Temperature
Through the analysis of peak broadening of energy-dispersive diffraction lines from a powdered sample, the yield strength of a-Si3N4 was investigated at a pressure of 9 GPa and temperatures up to 12341C. During compression at room temperature, the lattice strain deduced from peak broadening increased linearly with pressure up to 9.2 GPa, with no clear indication of strain saturation. While heat...
متن کاملInvestigation of influences of alloying elements and sintering temperature on the properties of high strength low alloyed sintered steel
Producing parts with high density and improved mechanical properties is one of the most important aims of powder metallurgy process. There are many factors for attaining modified properties in sintered parts but among them controlling type and quantity of alloying elements and manufacturing parameters such as compacting pressure, sintering temperature are the most effective. In this research, t...
متن کاملBond of High Strength Concrete with High Strength Reinforcing Steel
This paper presents a study about the bond of high strength concrete with high strength steel. Fourteen pull out tests were carried out to determine the bond. The concrete strength was about 70 MPa and the steel was a 500 MPa grade. Bar diameters used were 12, 16, 20, 25, 28, 32 and 36 mm. In order to investigate the effect of cover, each test was done twice, once in a 240 mm diameter concrete ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materia Japan
سال: 1997
ISSN: 1340-2625,1884-5843
DOI: 10.2320/materia.36.877