High temperature oxidation of pressureless sintered Si3N4 in oxygen atmosphere.
نویسندگان
چکیده
منابع مشابه
Microstructure and mechanical properties of pressureless sintered alumina-silver composites
The silver toughened alumina ceramics, which were fabricated via a conventional ceramic processing route using commercially available alumina and silver oxide powders as the starting materials, exhibit a higher fracture toughness (6 to 9 MPamo.5) than the monolithic alumina ceramic ( 2.5 to 3.0 MPamo.5). The weak interfacial bonding between the silver inclusions and the alumina matrix is charac...
متن کاملHIGH TEMPERATURE ELASTIC STRAIN EVOLUTION IN Si3N4-BASED CERAMICS
Tension experiments in vacuum were performed on a monolithic Si3N4 sample at 1375°C and a 20Vol% SiCp-Si3N4 composite sample at 1400°C using the new SMARTS diffractometer at the Los Alamos Neutron Science Center. The deep penetration of neutrons facilitated these in-situ studies. In particular, the hkl-dependent strains were measured and the results interpreted by Eshelby-based modeling for the...
متن کاملHigh Temperature Oxidation Behaviour of Nimonic - 115 Alloy in Presence of Sodium Salts at 850OC
The high temperature oxidation behaviour of Nimonic-115 industrial alloy has been investigated in presence of NaNO3, Na2CO3 and Na2O2 at 850oC in flowing air. The oxidation kinetics and effect of salt deposition for the period of 48 h were studied. The scale morphologies were determined on the basis of X-ray diffraction anal...
متن کاملHigh Temperature Erosion- Oxidation Behavior of Nickel- Based Alloys Containing Mo in Fluidized Bed Waste Incineration
High-temperature erosion-oxidation behavior of nickel-based alloys containing 0-7 wt.% Mo in fluidized bed waste incineration conditions was studied. A stream of hot condensed air with a flow rate of 25 L/min caused hot silica sand (700 °C) mixed with 0.5 wt.% of chloride salts to hit the specimens for 250 h. By removing the erosive factor, the high-temperature oxidation behavior of the alloys ...
متن کاملPressureless Sintering of Si3N4 Ceramic Using AlN and Rare-Earth Oxides
Using intermediate, liquid-forming compositions in the approach focuses on the Si3N4–R2O3 binary, where R2O3 is any (Y,La)2O3–AlN system as additives, fully dense Si3N4 ceramrare-earth oxide (or Y2O3) used singly or severally. After sinics with high strength at high temperature have been tering, this composition forms -Si3N4 and some refractory rareobtained by pressureless sintering. The cerami...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 1991
ISSN: 1880-7488,0514-5163
DOI: 10.2472/jsms.40.390