High Temperature Oxidation of Fe-Cr-(Al) and Fe-Cr-Ni Alloys under Tensile Stress
نویسندگان
چکیده
منابع مشابه
Oxidation – Nitridation of Ni-Cr-Al Alloys
A series of alloys containing 24-36 wt pct Cr and 13.5 – 25.0 wt pct Al was reacted with air at 1100 °C for 260 h. The products of isothermal reaction were scales of α-Al 2 O 3 plus small amounts of Cr 2 O 3 . These grew according to parabolic kinetics, interrupted by episodic weight losses caused by partial spallation. No nitridation occurred during the isothermal exposures. Reaction during th...
متن کاملAtomistic Study of Surfaces and Interfaces of Fe-Cr and Fe-Cr-Al Alloys
Surface and interface properties of Fe-Cr, Fe-Al, and Fe-Cr-Al are studied using Exact Muffin-Tin Orbitals and Monte Carlo methods and with x-ray photoelectron and Auger electron techniques. Surface composition is investigated as a function of oxidation (heating) time. Hard x ray photoelectron spectroscopy (HAXPES) is used to scan non destructively the compositions below the surface. It is foun...
متن کاملRoom Temperature Oxidation of Al-Cu-Fe and Al-Cu-Fe-Cr Quasicrystals
We have investigated formation of oxides on quasicrystalline and crystalline alloy surfaces of similar composition, in different oxidizing environments. This includes a comparison between a quaternary orthorhombic approximate of Al-Cu-Fe-Cr quasicrystal and the ternary AI-Cu-Fe quasicrystalline and crystalline phases. We noted that each sample showed the following common trends: preferential ox...
متن کاملHIGH TEMPERATURE TENSILE PROPERTIES OF NEW FE-CR-MN DEVELOPED STEEL
Nowadays, Ni-free austenitic stainless steels are being developed rapidly and high price of nickel is one of the most important motivations for this development. At present research a new FeCrMn steel was designed and produced based on Fe-Cr-Mn-C system. Comparative studies on microstructure and high temperature mechanical properties of new steel and AISI 316 steel were done. The results ...
متن کاملPreparation and Test of Fe / Cr / Al - Ni / Cr Composite Film Micro - heater
MEMS gas sensor is one of the development directions of the sensor, and it must work at a certain temperature, so micro heater is an important part of MEMS gas sensor. In this paper, aiming at the high cost and complex process of Pt film heater, we developed the research of Fe/Cr/Al and Ni/Cr cheap metals replacing Pt metal. With Fe/Cr/Al and Ni/Cr metal as the targets respectively, Fe/Cr/Al an...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1983
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.47.3_191