High-temperature deformation behavior of CdTe
نویسندگان
چکیده
منابع مشابه
High Temperature Deformation Behavior of Cr-containing Superplastic Iron Aluminide
Superplastic deformation and high temperature load relaxation behavior of coarse-grained iron aluminides with the composition of Fe-28 at.% Al have been investigated. A series of load relaxation and tensile tests were conducted at temperatures ranging from 600 to 850C. The flow curves obtained from load relaxation tests were found to have a sigmoidal shape and to exhibit stress vs. strain rate ...
متن کاملMicrostructure and High Temperature Deformation Behavior of Cast 310S Alloy
High temperature deformation behavior of cast 310S stainless steel has been investigated in this study by performing tensile and compression tests at temperatures from 900 to 1200C. Rectangular ingots of which the dimensions were 350×350×100 in millimeter were cast using vacuum induction melting. Phase equilibrium was calculated using the FactSage®, thermodynamic software and database. Thermal ...
متن کاملHigh Temperature Behavior of Dual Phase Steels
Dual phase steels with different martensite volume fraction and morphology were tensile tested at a temperature range of 25 to 5500C. Stress-strain curves of all steels showed serration flow at temperatures of 250 and 3500C, and smooth flow at the other temperatures. Both yield and ultimate tensile strengths increased with increasing testing temperature up to about 450<sup...
متن کاملHigh-temperature magnetic and optical properties of CdTe-MnTe superlattices
We present a study of magnetic and magneto-optical properties of CdxTe12x-MnTe superlattices up to the room temperature. A comparison of low-temperature exciton Zeeman effect and the measurements of the magnetization performed by superconducting quantum interface device magnetometer shows a perfect agreement with a model description, thus allowing for determination of Mn content profiles width ...
متن کاملhigh temperature behavior of dual phase steels
dual phase steels with different martensite volume fraction and morphology were tensile tested at a temperature range of 25 to 5500c. stress-strain curves of all steels showed serration flow at temperatures of 250 and 3500c, and smooth flow at the other temperatures. both yield and ultimate tensile strengths increased with increasing testing temperature up to about 4500c and then decreased at h...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Crystallographica Section A Foundations of Crystallography
سال: 1996
ISSN: 0108-7673
DOI: 10.1107/s0108767396084747